Garmin APPROACH G80 Owner's Manual

Also see for APPROACH G80: Quick start manual Owner's manual Quick start manual

Contents

Garmin APPROACH G80 Owner's Manual Manual pdf 12 page image

2 To remove the device, slide the device out of the holder.Installing the Cart MountFor the best GPS reception, position the mount so the front ofthe device is oriented toward the sky. You can install the mounton any bar that is approximately 19 mm to 38 mm (0.75 in. to1.5 in.).1 Select a secure location to mount the device where it doesnot interfere with the safe operation of your vehicle.2 Place the rubber disk on the back of the mount.The rubber tabs align with the back of the mount so it stays inplace.3 Place the mount on the bar.4 Attach the mount securely using the two bands .5 Align the tabs on the back of the holder with the mountnotches .6 Press down slightly and turn the holder clockwise until it locksinto place.Replacement O-ringsReplacement bands (O-rings) are available for the mounts.NOTE: Use Ethylene Propylene Diene Monomer (EPDM)replacement bands only. Go to http://buy.garmin.com, or contactyour Garmin dealer.Attaching the Lanyard CarabinerYou can use the lanyard carabiner to attach the device to a bagor belt loop.1 Thread the fabric end of the lanyard through the slots onthe back of the clip or holder.2 Thread the fabric end of the lanyard through the plastic loopon the opposite end of the lanyard.3 Insert the carabiner through the fabric loop on the end ofthe lanyard.Using the ClipYou can use the clip to attach the device to your belt, pocket, orbag. Go to www.garmin.com/golf to purchase accessories foryour device.1 Slide the bottom of the device into the clip until it clicks.2 To remove the device, slide the device out of the clip.Device CareNOTICEDo not store the device where prolonged exposure to extremetemperatures can occur, because it can cause permanentdamage.8 Appendix