Gardenline GLPT 2538 User Manual

Gardenline GLPT 2538 User Manual Manual pdf 21 page image

AFTER SALES SUPPORT0151 649 1500 1890 946244 www.einhell.co.uk4125cc Petrol Grass Trimmer – GLPT 2538 Maintenance and servicingAFTER SALES SUPPORT0151 649 1500 1890 946244www.einhell.co.uk4025cc Petrol Grass Trimmer – GLPT 2538CleaningCleaningCarrying out any cleaning work– The equipment should be cleaned thoroughly every time after it has been used.This applies particularly to the cutting tool and the guard hoods.– Keep the air vents and the motor housing free of dirt and dust as far as possible.Wipe the equipment with a clean damp cloth or blow it down with compressed airat low pressure.– It is easiest to remove dirt and grass immediately after use.– Clean the equipment regularly with a damp cloth and some soft soap. Do not usecleaning agents or solvents; these may be aggressive to the plastic parts in theequipment. Ensure that no water can get into the interior of the equipment.Maintenance and servicingGrinding the safety hood bladeYou will need a No 2PH cross point screwdriver to remove the screw, and a flat file tosharpen the bade.The safety hood blade (Fig. 7a/Item R) can become blunt over time. When you noticethis, undo the screw holding the safety hood blade to the safety hood. Clamp theblade in a vice. Sharpen the blade with a flat file and make sure that the angle of thecutting edge is not altered in the process. File in one direction only.Carburettor settingsNOTICE!Settings on the carburettor may only be made by authorizedcustomer service personnel. The air filter cover must beremoved before any work on the carburettor, as shown inFigures 10a and 10b.Replacing the line spool/cutting line1. Unscrew the retainer screw (Fig. 6a/Item G) in a counter-clockwise direction andremove (Fig. 6b). If you fail to do this by hand, use the key (Fig. 2/Item 10). You mayrequire no tools for this part of the maintenance, but if the spool retainer screw istoo tight, then use the supplied plastic key (Fig. 2/Item 10 & Fig. 5d).Fig. 6bFig. 6aG