16GB 2. Insert the two locking bolts 1 from outside through the holesin the two central sections 2 of the upright and secure to thelower sections of the upright 5 with two wing nuts 4.3. Screw the upper part of the upright with starting handle 3 tothe central sections of the upright 2 with two more lockingbolts 1 and the wing nuts 4.This completes the assembly of the hanle.Warning : Fit the upper section of the upright with startinghandle 3 in such a way that the plug 7 with the powercable 8 is on the right side (in direction of movement)(see fig.).4. Attach connection cable 8 to the handle with the two cableclips c.5. Operation1. Push connector of extension cable 0 on to the plug 7.2. Draw a loop of the extension cable 0 through the cable strainrelief device A 1 and suspend in position 2.This prevents inadvertent disconnection of the plug and socketconnection.3. Insert extension cable 0 into a mains socket.Danger of injury if the Aerator does not switch off auto-matically !V Do not remove or bridge safety devices fitted to theAerator (e.g. by tying the starting lever to the upperhandle) !DANGER ! The Aerator does not stop immediatelyAafter the motor has been switched off :V Never lift, tip or carry the Aerator with the motorrunning !V Never start on solid ground (e.g. asphalt).V Always maintain the safety distance between theaerator cylinder and the user as defined by theguide handle.1. Place Aerator on flat grass surface.2. Keep safety interlock B pressed down and pull starting lever Con the upper handle 3.The Aerator starts.3. Release safety interlock B.When in operation, the extension cable 0 must always beguided in the direction you are working and to the side ofthe area to be worked on.Always work away from the connection cable.Connect extension cable :Starting Aerator :0 A71 23BC3965124c87