Galcon DC-1 Operating Instructions Manual

Also see for Dc-1: Installation and operation instructions Installation and operating instructions

Contents

Galcon DC-1 Operating Instructions Manual Manual pdf 13 page image

134.3 Setting the Day of the Weekand Time For Cyclical and One-TimeIrrigation ProgramsThese programs enable you to pre-set the timeof valve opening. The number of days until thevalve opening appears on the display, to theright of the irrigation start time (above the word"days"). 0 days = program starts today; 1 day= program starts tomorrow, etc. (up to 30 days).1. Press until START I appears. The last opening time entered appearson the display.2. Press . The hour digits blink.3. Set the desired opening time by pressing or (Take note of AM and PMdesignations).4. Press until the digit to the right of the opening time blinks (The digit above theword "days").5. Set the number of days until the opening of the valve by pressing or .• Valve openings 2, 3 and 4 are canceled in this mode.4.4 Example: Programming a Cyclical Irrigation ScheduleLet's assume you want to program the irrigation controller to open the valve at 12:45PM, for a period of one hour, every 5 days.1. Set the irrigation duration as described in Section 3.4: Setting the Irrigation Duration.(Press until appears, then set the desired irrigation duration by pressingor ).2. Press until appears.3. Press a number of times (for all the days of the week) until On CE appears blinkingon the display.4. While the display is still blinking, press or until "5 days" appears on the display,representing the irrigation frequency.5. Press . START I is displayed.6. Press . The hour digits blink.7. Press until the hour digits change to 12 (PM).8. Press until the minute digits change to 45.