Galaxy Digital Logic 400 TurboCharge Instruction Manual

Galaxy Digital Logic 400 TurboCharge Instruction Manual Manual pdf 1 page image

400 / 600 / 1000 Watt +Turbo Charge ®*** READ THESE IMPORTANT INSTRUCTIONS BEFORE USING YOUR BALLAST ***INSTRUCTION MANUALKEEP ORIGINAL PACKAGING— allreturns need to be in the original packaging inorder to avoid product damage during shipping.Any damage to products not in their originalpackaging will not be covered under warranty.SAFETY FIRST! Failure to observe thefollowing safety warnings may result inserious injury. In addition, failure to observethese safety warnings will result in a waiver ofall liabilities and will void all warranties.WARNING If the exterior of the lamp is damaged,replace lamp immediately. When re-lamping, make sure lamp has timeto cool before touching. Make sure power cord and lamp cord areconnected properly. Disconnect power before re-lamping. DO NOT make contact with the interior ofthe socket while power is on. DO NOT operate light systems in wet locations. DO NOT attempt to rewire or reconfigureyour system, it will void warranty and couldcause serious safety hazards (i.e. powercord, lamp cord, lamp socket or ballast). DO NOT hang by power or lamp cord.  DO NOT plug system into supply voltageother than what is designated on ballast. Keep away from children. DO NOT alter or modify this unit in anyway. It may cause bodily injury or death asthis is a high power electrical device. DO NOT submerse in water or splash wateron the unit. DO NOT plug or unplug the lamp cordwhile the ballast is energized.These high performance Electronic Ballastsare extremely efficient. They have a highpower factor and high luminous efficacy. It’sstable performance creates constant poweroutput even when power fluctuates (powersurge). Short circuit protection technologyprevents damage to the lamp and otherballasts connected to the same circuit.1. INSTALLATION PROCEDURE DO NOT alter or modify the electronicballast in any way. Not only may it damagethe unit, it will void the warranty. Lamp power rating must match electronicballast power rating.OUTPUT TO HPS/MH LAMPConnect lamp cord with male plugto dual universal female lamp cordreceptacle on ballastWARRANTY This unit, when properly used will provide you with years of service. It iscovered under a 3 year warranty. This warranty will be voided if the unit is misused, abusedor altered. Warranty repair or replacement will be at the sole discretion of the manufacturer.Defective units need to be returned to the place of purchase with proof of purchase/receipt.This warranty is expressly in lieu of all other warranties, expressed or implied, including thewarranties of merchantability and fitness for use and of all other obligations or liabilitieson the part of the seller. This warranty shall not apply to this product or any part thereofwhich has been damaged by accident, abuse, misuse, modification, negligence, alterationor misapplication. Manufacturer makes no warranty whatsoever in respect to accessoriesor parts not supplied by manufacturer. This warranty does not cover labor, materials,equipment, etc. to install or de-install lighting fixtures or any other product. Buyers sole andexclusive remedy shall be the repair or replacement of the defective product at the sellerssole discretion. This warranty shall apply only to the United States, including Alaska, Hawaiiand territories of the United States and Canada.RETURNING UNITS Please contact your retail store for returns.CONNECT APPROPRIATE AC POWERPLUG HERE AC input 120(included)or 240V(purchase separately)The Galaxy Digital Logic offers our exclusive Smart Volt® feature, allowing operation on either120 or 240 volt power by simply plugging in the appropriate power cord. There is no furthermodification necessary. It comes with a 120 volt power cord. To run this ballast on 240 volt,purchase the 240 volt power cord separately (part #903082 six foot or #903084 twenty foot).2. SPECIFICATIONS 120-240 Volts Power source frequency: 50/60Hz Power Factor (cosø): > 0.99 Ambient Temp: 50˚F to 120˚F Crest Factor: < 1.5 Acoustic Resonance: none Total Harmonic Distortion:(THD): < 10.0%www.galaxyballasts.comPart 18 compliance This device complies with Part 18 of the FCC Rules.Advisory statementThis product may cause interference to radio equipment andshould not be installed near maritime safety communicationsequipment or other critical navigation or communicationequipment operating between 0.45-30 MHz.The interference potentialof the device or systemThe interference potential of the device or system is theoperating frequency; 65 kHz.Maintenance of the system Unplug the unit, wait 30 seconds, and plug the unit back in.Simple measures that can be takenby the user to correct interferenceMove the unit away from any radio device. This product contains delicate electronic components. This means that if it isplaced near an object that transmits radio signals, it could cause interference.This could be, for example, mobile telephones, walkie talkies, CB radios, remotecontrols and microwaves. If interference occurs, move such objects away fromthe appliance.Galaxy Digital Logic Select-A-Watt 400/600/1000/Turbo Charge 120/240 Volt:FCC#: 2AEHV9022323. NOTESGalaxy Electronic Ballasts will operate with Metal Halide lamps and High Pressure Sodiumlamps that are rated at the proper wattage. This unit offers short-circuit and power fluctuation.MAINTENANCE Regularly check the ballast for dust or dirt buildup.Clean the outside of the fixture using a dry or damp cloth. Regularly check the wiring of the product to ensure it is undamaged.

/ 2

This manual is suitable for:

Digital Logic 1000 TurboCharge Digital Logic 400 TurboCharge Digital Logic 600 TurboCharge

Galaxy Digital Logic 400 TurboCharge Instruction Manual

Product

Learn More

Legal