Galaxy DX 48T Owner's Manual

Contents

Galaxy DX 48T Owner's Manual Manual pdf 5 page image

PROCEDURE TO RECEIVE AND TRANSMITREAR PANELA. MICROPHONE- 8 -MADE IN TAIWAN1 2ANT.EXT.SP._PA.SP.+ POWER3 4 The push-to-talk switch on the microphone controls the receiver and transmitter. Pressthe switch and the transmitter is activated, release switch to receive. When transmitting,hold the microphone two inches from your mouth and speak clearly in a normal voice.This transceiver comes complete with a low impedance dynamic microphone.B. PROCEDURE TO RECEIVE1. Be sure that power source, microphone and antenna are connected to the properconnectors before going to the next step.2. Turn VOL knob clockwise to apply power to the radio.3. Set the VOL for a comfortable listening level.4. Set the MODE switch to the desired mode.5. Listen to the background noise from the speaker. Turn the SQ knob slowlyclockwise until the noise just disappears. The SQ is now properly adjusted. Thereceiver will remain quiet until a signal is actually received. Do not advance thecontrol too far or some of the weaker signals will not be heard.1. ANTENNA: This jack accepts a 50 ohm coaxial cable with a PL-259 type plug. 6. Set the CHANNEL selector switch to the desired channel.2. DC POWER: This jack accepts the 13.8V DC power cable with built-in fuse. Thepower cord provided with the radio has a black and red wire. The black goes tonegative and red goes to positive.7. Set the RF GAIN control fully clockwise for maximum RF gain.C. PROCEDURE TO TRANSMIT1. Select the desired channel of operation.3. PA SP: This jack is for PA operation. Before operating, you must first connect aPA speaker (8 ohms, 4W) to this jack. 2. Set the MIC GAIN control fully clockwise.4. EXT. SP: This jack accepts a 4 to 8 ohm, 5 watt external speaker. When theexternal speaker is connected to this jack, the built-in speaker will be disabled. 3. If the channel is clear, depress the push-to-talk switch on the microphone and speakin a normal voice.- 9 -