ENGLISH• 13 •Making hot water:1. Follow the procedure described under“Preparation”.2. Turn the power switch (1) to “1”.3. Allow about 6 minutes for the machine to reachits proper operating temperature.4. Place a pitcher under the steam nozzle (8).5 Slowly turn steam valve knob (7) counterclockwise and turn the hot water/brew switchto “1” to release hot water.N.B.:Dispensing should not exceed 60seconds.6 When you have prepared the desiredquantity of hot water, turn steam knobclockwise and hot water/brew switch to “0”to shut off hot water and remove pitcher.7 NOTE:If you want to make espressoimmediately after making hot water, the tem-perature of the machine boiler must bebrought down to a brewing temperature.Otherwise, espresso may taste “burned”.Keeping it clean:1 IMPORTANT:the steam nozzle should becleaned after each use in order to avoid buildup of milk deposits that are very difficult toclean. Cleaning is made easy as can be seenin the DESCRIPTION OF PARTS. The outerpart of nozzle can be removed by pullingdownward.The outside of the steam pipe can be cleanedwith a damp cloth.The steam jet is cleaned by running a shot ofsteam through it.The hole in the steam nozzle must be keptopen. A needle may be used.2 Clean filter holder and filter in warm waterafter use.4 Slowly turn steam valve knob (7) counterclockwise to release steam.IMPORTANT:The more you turn theknob, the greater the steam pressure forfrothing.5 When you have made enough froth, turnsteam knob clockwise to shut off steam.Put steam switch (4) to “0” position.6 Top each cup of cappuccino with a dashof cinnamon, cocoa, nutmeg. Serve.7 NOTE: If you want to make more espres-so immediately after steaming milk, themachine boiler must be refilled with waterand temperature brought down to abrewing temperature.Otherwise, espresso may taste “burned”.To do this: place an empty cup on the dripplate.Do not insert filter holder.Turn hot water/brew switch (2) to “1”letting cup fill with water.Turn brew switch “0”.You may now proceed to make moreespresso.To do this: place an empty cup on drip plate.Do not insert filter holder. Turn hot water/brew switch (2) to “1” letting cup fill withwater. Turn brew switch “0”.You may now proceed to make espresso.Air intake to be keptclean and free fromresidues.Pay attention as theTurbo-Frothersteam nozzlecould be hot!