GEAppliances PVM1790 Installation Instructions Manual

Also see for CVM1750: Owner's manual

GEAppliances PVM1790 Installation Instructions Manual Manual pdf 9 page image

9Installation InstructionsDETERMINING WALL PLATE LOCATION UNDER YOUR CABINETCYour cabinets may have decorative trim that interfereswith the oven installation. Remove the decorative trimto install the oven properly and to make it level.THE OVEN MUST BE LEVEL.Use a level to make sure the cabinet bottom is level.If the cabinets have a front overhang only, with no backor side frame, install the mounting plate down the samedistance as the front overhang depth. This will keepthe oven level.Measure the inside depth of the front overhang.Draw a horizontal line on the back wall an equaldistance below the cabinet bottom as the inside depthof the front overhang.For this type of installation with front overhang only,align the mounting tabs with this horizontal line, nottouching the cabinet bottom as described in Step D.Plate position – beneath flat bottomcabinetPlate position – beneath recessed bottomcabinet with front overhangMounting Plate TabsTouching the CabinetBottomMounting Platewith Tabs BelowCabinet Bottomthe Same Distanceas the FrontOverhang DepthPlate position – beneath framed recessedcabinet bottomMounting Plate TabsTouching the BackFrame30s to Cooktop30s to Cooktop123At least 30s, up to 36s