GEAppliances 30" Installation Instructions Manual

Contents

GEAppliances 30" Installation Instructions Manual Manual pdf 1 page image

Installation Instructions30" Electric Slide-In RangesQuestions? Call 1.800.561.3344 or visit www.GEAppliances.caREMOVE PACKAGING MATERIALSFailure to remove packaging materials could result in damage to theappliance. Remove all packing parts from oven, racks, heating elementsand drawer. Also, remove protective film and labels on the door, cooktop(do not remove side protection on glass cooktops) and backguard.Do not remove protective channel from sides of glass cooktop, if applicable,until later in installation.NOTE : Cut the orange shipping ties from the power cord, being careful notto damage the cord.1TOOLS YOU WILL NEEDDrill with 1/8" BitSafety GlassesAdjustable WrenchLevelTape Measure Pliers1/4" Nut DriverBEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT—Save these instructions for local inspector’s use.• IMPORTANT—Observe all governing codes and ordinances.• Note to Installer – Be sure to leave these instructions with Consumer.• Note to Consumer – Keep these instructions for future reference.• Skill level – Installation of this appliance requires basic mechanicalskills and advanced electrical skills.• Proper installation is the responsibility of the installer.• Product failure due to improper installation is not covered under warranty.WARNING: This appliance must be properlyconnected by means of the supplied cord and plug. If your kitchen does nothave a receptacle, you must have one installed by a licensed electrician.PREPARE THE OPENING (FOR INDOOR USE ONLY)If the countertop area is not flat, excess tension may be applied to the glasscooktop causing breakage and voiding the warranty. Make sure the wallcovering, countertop, flooring and cabinets around the range can withstandthe heat (up to 93˚C [200˚F]) generated by the range.A. Allow 76.2 cm (30") minimum clearance between surface units and bottomof unprotected wood or metal cabinet, or allow a 61 cm (24") minimumwhen bottom of wood or metal cabinet is protected by no less then 6.3 mm(1/4") thick flame retardant millboard covered with no less than No. 28 MSGsheet metal .38 mm (.015") thick, .38 mm (.015") thick stainless steel,.63 mm (.025") aluminum or .5 mm (.020") copper.B. A minimum 15.2 cm (6") spacing to surfaces less than 38.2 cm (15")above the cooktop and adjacent cabinetry is recommended to reduceexposure to steam, grease splatter and heat. Allow 6.3 mm (1/4")minimum clearance at the back wall.To reduce the risk of burns or fire when reaching over hot surface elements,cabinet storage space above the cooktop should be avoided. If cabinetstorage space is to be provided above the cooktop, the risk can be reducedby installing a range hood that projects at least 12.7 cm (5") beyond the frontof the cabinets. Cabinets installed above the cooktop must be no deeperthan 33 cm (13").275.89 cm (29.88”) – Metal cooktops79.71 cm (31.38”) – Glass cooktops11.66 cm (4.59”)Height from floorto cooktop91.44 cm (36”)Range Wide75.89 cm (29.88”)59.82 cm (23.55”)38 cm (15") min.59.37 cm(23-3/8")Orient electrical receptacle so the length is parallel to the floor.63.5 cm (25")76 cm–76.3 cm(29-15/16"–30-1/16")91.1 cm–96.5 cm(35-7/8"–38") fromfloor to countertop6.98 cm (2-3/4")NOTE: Use a 122 cm (4') powercord to prevent interference withthe storage drawer. Power cords137 cm (4-1/2') to 182.2 cm (6')long may have to be dressedto allow for proper drawer closing.76.2 cm(30") min.14.2 mm (9/16")6.3 mm (1/4")min. flat13.65 cm (5.3/8")11.27 cm(4.44")3.1 cm (1-1/4") min. from countertopto top of cabinet drawer.Front surfaceof countertop80.06 cm (31.52”)If the control panel measures 80.06 cm (31.52”) as shownabove AND if the countertop has a raised edge, shave raisededge to clear the control panel as shown below.Wall63.5 cm (25")typically1.4 cm(9/16")min.flatmin. flatSmooth cut76 cm–76.4 cm (29-15/16"–30-1/16")1.4 cm (9/16")min. flatFlat areaR1.58 mm(1/16")91.4 cm (36")See noteBabove.See noteAabove.222D6038P00355.30 cm (21.77”)Door clearancefrom front surfaceof countertopNOTE: Installation information forreference only. See InstallationInstructions shipped with product forcomplete details and before attemptingto install. Anti-tip bracket must beattached to the floor or wall to holdeither right or left rear leg leveler. Makesure leg leveler reengages the bracketwhen range is moved for any reason.WARNING• All ranges can tip• Injury to persons could result• Install anti-tip bracketpacked with range• See Installation InstructionsAdjacent CabinetOr Final LocationOf Range Side Panel WallFloor-WoodBracketSideRearLevelingLeg Floor-ConcreteAttachment To WallBracketWallPlateScrew MustEnter WoodOr Metal59.37 cm(23-3/8")6.98 cm(2-3/4")1.58 mm (1/16")

/ 4

Related manuals for GEAppliances 30"