GEAppliances 234D2028P002 Owner's Manual

Contents

GEAppliances 234D2028P002 Owner's Manual Manual pdf 10 page image

10About reversing the door.3 Loosen the bottom 2 right side hinge screws. Remove thedoor and place it on a protected flat surface to avoid anydamage. Remove both the Blind Plate and the StrikePlate and install them in opposite positions.4 Remove the 4 door hinge screws, 4 edge screws, and 8inside screws. Lift the inner door upwards using a flatblade screwdriver.Reversing the DoorTools needed: Standard #2 Phillips screwdriver Tape-tipped putty knife Small flat blade screwdriverBefore you StartUnplug the dryer from its electrical outlet.1 Open the door approximately 170 degrees. With a puttyknife, remove the 4 plastic covers located along the leftside of the front panel and set them aside.2 Remove the bottom screw from each hinge (right side)and partially insert them into the top left side hingeholes.NOTE: All 4 front panel hinge screws will now be in the tophinge holes - 2 on the left and 2 on the right.Plastic Cover (4)Left side offront panelBlind plateInner doorStrike plateDoor hingescrewsInner doorOuter doorInside screwsInside screwsEdgescrews