GE r08654v-1 Installation Instructions Manual

Also see for JTP70: Installation instructions Installation instructions Owner's manual Brochure Owner's manual

Contents

GE r08654v-1 Installation Instructions Manual Manual pdf 16 page image

16WARNING: Mountingscrews must be used. Failure todo so could result in the ovenfalling out of the cabinet causingserious injury.Installation InstructionsSecuring the Oven in the OpeningDrilling the Pilot Holes andMounting the Ovena. Drill through the mounting holes (top andbottom) of the side trim, for the #8 screwsprovided.b. Secure the oven to cabinet with screwsprovided.NOTE: If the cabinet is particle board, youmust use #8 x 3/4” particle board screws.These may be purchased at any hardwarestore.Sliding the Oven Into theOpeninga. Loop (do not tie) a 36” (91 cm) stringaround the conduit before the oven is slidinto place. This will keep the conduit fromfalling behind the oven.b. Lift oven into cabinet cutout using the ovenopening as a grip. Carefully push againstoven front frame. Do not push againstoutside edges.c. As you slide the oven back, pull the stringso that the conduit will lie on top of theoven in a natural loop.d. When you are sure the conduit is out of theway, slide the oven 3/4 way back into theopening. Remove the string by pulling onone end of the loop.NOTE: Before drilling the pilot holes,make sure the oven is pushed as farback into the opening as it will goand centered.The screws mustbe a minimum of1/4” (6 mm) fromthe front of thecutout.CC1 C2Pull out onstring loopwhile pushingthe oven intothe cabinetMountingHoleLocations(HoleLocationsmay vary)