7-6 C70 Capacitor Bank Protection and Control System GE Multilin7.1 COMMANDS 7 COMMANDS AND TARGETS77.1.3 VIRTUAL INPUTSPATH: COMMANDS Ö VIRTUAL INPUTSThe states of up to 64 virtual inputs are changed here. The first line of the display indicates the ID of the virtual input. Thesecond line indicates the current or selected status of the virtual input. This status will be a state off (logic 0) or on (logic 1).7.1.4 CLEAR RECORDSPATH: COMMANDS ÖØ CLEAR RECORDSThis menu contains commands for clearing historical data such as the event records. Data is cleared by changing a com-mand setting to “Yes” and pressing the ENTER key. After clearing data, the command setting automatically reverts to “No”.7.1.5 SET DATE AND TIMEPATH: COMMANDS ÖØ SET DATE AND TIMEThe date and time can be entered here via the faceplate keypad only if the IRIG-B or SNTP signal is not in use. The timesetting is based on the 24-hour clock. The complete date, as a minimum, must be entered to allow execution of this com-mand. The new time will take effect at the moment the ENTER key is clicked. COMMANDS VIRTUAL INPUTSVirt Ip 1OffRange: Off, OnVirt Ip 2OffRange: Off, On↓MESSAGE Virt Ip 64OffRange: Off, On COMMANDS CLEAR RECORDSCLEAR USER FAULTREPORTS? NoRange: No, YesCLEAR EVENT RECORDS?NoRange: No, YesCLEAR OSCILLOGRAPHY?NoRange: No, YesCLEAR DATA LOGGER?NoRange: No, YesCLEAR UNAUTHORIZEDACCESS? NoRange: No, YesCLEAR DIRECT I/OCOUNTERS? NoRange: No, Yes. Valid only for units with Direct Input/Output module.CLEAR ALL RELAYRECORDS? NoRange: No, Yes COMMANDS SET DATE AND TIMESET DATE AND TIME:2000/01/14 13:47:03(YYYY/MM/DD HH:MM:SS)
