GE Tetra GECLPS5-2 Installation Manual

GE Tetra GECLPS5-2 Installation Manual Manual pdf 1 page image

Tetra® LED Control Module(GECLPS5-2)GELightingInstallation Guideimagination at work24VoltSave These InstructionsUse only in the manner intended by the manufacturer.If you have any questions, contact the manufacturer.WARNING/AVERTISSEMENTRISK OF ELECTRIC SHOCK• Disconnect power at fuse box or circuit breaker beforeservicing or installing product.• Properly ground Tetra® power supply.RISK OF FIRE• Use only Tetra® supply wire to make connection fromTetra® power supply to Tetra® LED strip.• Use only approved wire for input/output connection.Minimum size 18 AWG (0.82 mm2)• Follow all local codes.RISQUES DE DÉCHARGES ÉLECTRIQUES• Coupez l’alimentation électrique à la boîte de fusibles ou au disjoncteur avantl’entretien ou l’installation du produit.• Assurez-vous de correctement mettre à terre l’alimentation électrique Tetra®.RISQUES D’INCENDIE• N’utilisez que le fil d’approvisionnement Tetra® pour faire la connexion entrel’alimentation Tetra® et la bande DEL Tetra®.• N’utilisez que des fils approuvés pour les entrées/sorties de connexion. Tailleminimum 18 AWG (0.82 mm2).• Respectez tous les codes locaux.CAUTION/ATTENTIONRISK OF INJURY• While performing installations described, gloves, safety glassesor goggles should be worn.RISQUE DE BLESSURE• Lors de l’exécution des installations décrites, des gants, des lunettes desécurité ou des lunettes de protection doivent être portées.Prepare Electrical WiringElectrical Requirements• Limited to use in dry and damp locations.• The grounding and bonding of the LED Driver shall be done inaccordance with National Electric Code (NEC) Article 600.• Follow all National Electric Codes (NEC) and local codes.• These products are only suitable for connection to a circuitfrom a Class 2 power source. These products have not beenevaluated for use when connected to a power source that doesnot comply with Class 2 voltage and energy limited supplies.BEFORE YOU BEGINRead these instructions completely and carefully.This device complies with part 15 of the FCC Rules. Operationis subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) this device mustaccept any interference received, including interference thatmay cause undesired operation.Note: This equipment has been tested and found to complywith the limits for a Class A digital device, pursuant to part15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference when theequipment is operated in a commercial environment. Thisequipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with theinstruction manual, may cause harmful interference to radiocommunications. Operation of this equipment in a residentialarea is likely to cause harmful interference in which case theuser will be required to correct the interference at his ownexpense.This Class [A] RFLD complies with the Canadian standardICES-003. Ce DEFR de la classe [A] est conforme à la NMB-003du Canada.LED Control Module Features• LED Control Module for GECLPS5 and GECLPS6 retrofit.• UL: Class 2 input.

/ 4

Related manuals for GE Tetra GECLPS5-2