Menu
GE Quik Bridge 60-841-43 Installation Instructions Manual
          |
1Dhyyhv D
pvZZZ*(,QWHUORJL[FRPB@Dr
ytv9ProductSummary The purpose of the Quik Bridge ® Euro Repeater SAW is to extend the range of wireless securitysystems. The repeater accomplishes this by receiving and retransmitting signals from LearnMode™ sensors, wireless touchpads, and other repeaters. The repeater is ideal for the followingapplications:• Installations where sensors are either beyond panel reception or cannot pass the sensor test.• As a substitute for preamps in installations where panel antennas are shielded by metal.The repeater will retransmit all signals received from compatible sensors and wireless touchpads(see “Compatibility”). It will retransmit signals received from another Euro Repeater SAW if theDIP switches of both repeaters have been set accordingly (see “Setting the DIP Switches”).Repeater FeaturesRepeater features include:• Supervisory reports to the panel every 15 minutes.• A tamper switch that causes an alarm transmission if the repeater cover is removed.• A tamper alarm if the antenna is removed.• Support for a rechargeable lead acid backup battery.• A loop-antenna receiver, which improves reception through spatial diversity.• A low battery trouble report when the backup battery is low.• An AC power failure alarm when AC power has failed for more than 15 minutes.• Jam detection, which alerts the panel when the receiver detects “noise” on the same fre-quency that the transmitters use for alarm transmissions.Powering OptionsThe repeater must be hardwired into theelectrical system of the premises. Electri-cal codes will vary depending upon thecountry and city where the system isinstalled. Have a qualified person connectthe 220-240VAC (50 Hz) power cable tothe power input terminal as shown in Fig-ure 1. A minimum of 14-gauge powerwire must be used. The power wiresshould not be routed near the receiver cir-cuitry on the top of the circuit board.NoteThe repeater does not have a power switch.A readily accessible power disconnectdevice must be incorporated in the building installation wiring to comply with local safety standards.A 12 VDC lead acid battery, such as the Panasonic LCR12V1.3P, may be installed as a backuppower source. Connect the battery to the circuit board as shown in Figure 1. The terminals of thebattery should face towards the right side of the enclosure (see Figure 2).TOACPOWERSOURCETOEARTHGROUNDTOPOSITIVEBATTERYTERMINALTONEGATIVEBATTERYTERMINALTOACPOWERSOURCEFigure 1. AC Power and DC Battery ConnectionsThere is a risk of explosion if an incorrect type of battery is installed.Warning!9pr Iir
) #%% & Sr @6
vy !"Rvx7
vqtr @
Srrhr
T6X0RGHO1R |
Related manuals for GE Quik Bridge 60-841-43
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved