GE Profile PVM9005FMDS Installation Instructions Manual

Also see for Profile PVM9005 Series: Owner's manual Owner's manual Installation instructions

18 49-40755 Rev.1USE TOP CABINET TEMPLATE FORPREPARATION OF TOP CABINETYou need to drill holes for the top support screws,a hole large enough for the power cord to fit through,and a cutout large enough for the exhaust adaptor.B2• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on the TOPCABINET TEMPLATE.CAUTION Wear safety goggles when drillingholes in the cabinet bottom.Installation InstructionsADJUST BLOWER MOTORADJUST BLOWER MOTOR (cont.)B3B3Remove the screws holding the blower unit andthe screws securing the blower plate. Removethe blower plate from the outer case by sliding ittoward the back of the microwave and pulling up.1BlowerPlateBlower Motor ScrewsBlowerMotorScrew2 Carefully pull out the blower unit. The wires willextend far enough to allow you to adjust theblower unit.Roll the blower so that fan blade openings arefacing the top of the oven. Place the blowerback into the opening.Slide the blower plate back onto the microwaveby placing the side tabs into the slots andpushing gently until the back tab is seated intothe rear slot. Replace 3 screws.Note: Make sure the wires remain routed throughthe openings in the motor frame. To avoid damageto the fan motor wiring, insert motor carefully suchthat the fan motor wiring does not contact themicrowave power cord bracket.34Back ofMircrowaveRotate 90°Back ofMircrowaveFan BladesWiresWARNING Risk of Electric Shock.Can cause injury or death. Do not pull orstretch the blower unit wiring. Make sure thewires are not pinched.Side TabSide Slot Rear SlotRear Tab