GE Monogram ZVC30 Installation Instructions Manual

Also see for GE Monogram ZVC30: Installation instructions

Contents

GE Monogram ZVC30 Installation Instructions Manual Manual pdf 8 page image

8Design InformationPRODUCT DIMENSIONS4″46-1/2″21-1/4″1/2″3-7/8″7-1/2″ A 1/2″ wide flange surrounds the outside edge ofthe insert sleeve.Remote Location for the ControlThe control may be removed from the hoodand installed into a wall or countertop. A 30-ft.length of wire is supplied to accommodate mostinstallations. A blanking plate covers the openingwhen the controls are removed.The overall size of the control is 4-1/4″ wide and2-1/4″ deep.We recommend that the cutout in granite or otherhard surfaces be made before the countertop isinstalled.The stainless steel liner is shipped with each hoodinsert. This non-combustible liner protects theunderside of the canopy.Custom LinerIf you are not using the supplied liner, you mayconstruct a custom non-combustible liner. Use thesupplied liner as a template. The opening must be38-3/4″W x 13-3/16″D. 3/4″ thick material mustsurround the opening to allow the sleeve lockingclips to engage. The insert sleeve inside the cabinetshould be positioned 1/2″ from the rear wall sothat the center of the 8″ duct is 5-1/2″ from therear wall.*OpeningZVC48The custom canopy must be sized to fit the insertsleeve. Construct the canopy with an openingthat is:38-3/4″W x 13-3/16″DThe opening must be constructed of 3/4″ thickmaterial to allow the sleeve locking clips toengage.The Supplied LinerDimensions and Specifications (in inches)Outside DimensionsThe Insert Sleeve38-1/2″ 13″14″29-1/2″1/2″1/2″1/2″13″1-11/16″3-11/16″Control cutout14″39-1/2″Front sideFront side