GE Monogram ZV900 Owner's Manual

Also see for Monogram ZV900: Installation instructions Owner's manual Installation instructions Owner's manual

Contents

GE Monogram ZV900 Owner's Manual Manual pdf 9 page image

9Questions?Use thisproblemsolver!PROBLEM POSSIBLE CAUSEFAN AUTOMATICALLY • The Sensor feature will automatically turn the fan on at theTURNS ON AND CAN MED setting and the display will show AUTO MODE ON if cookingNOT BE TURNED OFF temperatures become too hot. The fan will stay on for a minimumof 3 minutes and will then turn off when temperatures cool to anappropriate level.FAN DOES NOT • A fuse may be blown or a circuit breaker tripped. Replace fuse orOPERATE WHEN reset circuit breaker.TURNED ON • The power disconnect switch inside the hood may be switched off.Remove the metal grease filter and the charcoal filter (if present) andflip the switch on.FAN FAILS TO CIRCULATE • Check to be sure the metal grease filter and the charcoal filterAIR OR MOVES AIR (if present) are clean. Clean the metal grease filter (see the MetalSLOWER THAN NORMAL grease filter section) and, if the hood is recirculated (not vented to theoutside), replace the charcoal filter (see the Charcoal filter section).If cleaning and replacing the filters does not correct the problem,call for service.FAN KEEPS GOING • The motor is probably overheating and turning itself off. This canOFF AND ON be harmful to the motor. Check to be sure the filter is clean. If offand on cycling continues, call for service.LIGHT WILL NOT STAY • Use 12 volt, 20 watt halogen bulbs with a G4 base and make sureON HIGH SETTING OR they are inserted securely. See the Light bulbs section.“WRONG WATT BULB”APPEARS IN THE DISPLAYTHE HOOD CONTROLS • Disconnect power to the hood by removing the fuse or turning theOR DISPLAY ARE NOT circuit breaker off in the home fuse box. Wait 30 seconds to allow theOPERATING CORRECTLY hood controls to reset and then replace the fuse or move the circuitbreaker back on.SEQUENTIAL PRESSES • It is normal for the light and fan buttons to cycle around through theOF THE LIGHT OR FAN settings so that you can easily set the controls to the desired setting.BUTTONS WILLSOMETIMES CHANGETHE SETTING FROM THELOWEST SETTING–TO OFF–TO THE HIGHEST SETTING,OR FROM THE HIGHESTSETTING–TO OFF–TO THELOWEST SETTINGWHEN PRESSING THE • For your convenience, it is normal for the lights and fan to rememberPOWER ON/OFF BUTTON their last setting when you press the Power On/Off button. If youTO TURN ON THE LIGHT, want only the lights on, press the “FAN +” (or the “FAN –” ) button untilTHE FAN COMES ON “Off” is in the display. When you power the hood up next time, onlyINSTEAD the lights will function.The Problem SolverGlass Canopy Hood