GE JVM2052 Installation Instructions Manual

Also see for JVM2052: Installation instructions Owner's manual Owner's manual Owner's manual Installation instructions

Contents

GE JVM2052 Installation Instructions Manual Manual pdf 10 page image

Installation Instructions[_ PREPARE THE VENTINGAWARNING:• To avoid the risk of property damage, unplug themicrowave oven or disconnect power at the sourceby removing the fuse or throwing the circuit breaker.• To avoid the risk of personal injury, wear protectivegloves when handling the mounting plate.• DO NOT PULLOR STRETCHTHE BLOWERWIRING!Pulling and stretching the blower wiring could resultin electrical shock.NOTE:Your microwave oven is shipped with the blowerassembled for room venting. If you want wall-ventedor roof-vented installation, you must change the blower,as detailed below.F_ BEFORE YOU START[] Remove any shipping materials and parts frominside the microwave oven.[] Cover the counter top or cooktop with a thick,protective covering to protect it from damageand dirt.A thick,protectivecoveringNOTE: If you have a free-standing range, disconnectit, move it onto a piece of cardboard or hardboardand pull it away from the wall. This allows you toget closer to the upper cabinet and back wall foreasier measuring and drilling.r_ REMOVE THE MOUNTING PLATERemove the mounting plate screw(s)(1 or 2 screws)from the mounting plate as shown and discard.MountingplateMountingplate Mountingplate screw(s)screw(s)(1 or2 Mountingplate (1 or2ontro,/pane I'..Jql l I!1 1side . ' : Control ---_,-- _.... panel /%%%This plate will be used as the rear mounting plate.(It will be used to locate and mark the mountingholes on the rear wall.Locate the exhaust adapter, grease filters andhardware packet.At this point, remove any adhesive tape (if there isany), on the exhaust adapter, the grease filters andthe power supply cord.I_ INSTALLATION TYPESRoom-Vented (recirculating)Installation:This oven is shipped assembled for room venting.Wall-Vented Installation:% Remove one blower unit mounting screw and oneor two blower plate screw(s). Remove the blowerplate from the cabinet._______--Blowerplate_!.............i Mountingscrewi..........! _"_J (option)__ BlowerplateBlowerunit _ Backplate_ _-_y_b_h II_!_ ' Blowe[unity-'.__ mountingscrewParts "B" (option)%%Carefully lift the blower unit out of the microwaveoven.Use side cutters or tin snips to cut and removeknockouts "B" from back plate. Discard theknockouts. Be careful not to distort the plate.KnoclParts"B"10