GE JVM2052 Installation Instructions Manual

Also see for JVM2052: Installation instructions Owner's manual Owner's manual Owner's manual Installation instructions

Contents

GE JVM2052 Installation Instructions Manual Manual pdf 10 page image

Installation Instructions| ALIGNING THE WALL PLATEHoleC CenterlineNotches00000000 0 0000000!AreaEDrawa VerticalLineon Wall_-_ from CenterofTopCabinetHole BA CAUTION: Weor glovesto avoid cutting fingers on sharp edges.HoleD[]%%Draw a vertical line on the wall at the center of the]0" wide space.Use the mounting plate as the template for the rearwall. Place the mounting plate on the wall, makingsure that the tabs are touching the bottom of thecabinet or the level line drawn in Step C for cabinetswith front overhang. Line up the notch and centerlineon the bottom of the mounting plate to the centerlineon the wall.While holding the mounting plate with one hand, drawcircles on the wall at holes A, B, C and D (seeillustrationabove/actual plate marked with arrows). Four holesmust be used for mounting.NOTE:Holes C and D are inside area E.If neither C nor Dis in a stud, find a stud somewhere in area E and drawa fifth circle to line up with the stud. It is important to useat least one wood screw mounted firmlg in o stud tosupport the weight of the microwave oven.Set the mounting plate aside.A WAR NING: RiskofElectricShock.Cancause injury or death. Take care to not drill into electricalwiring inside walls or cabinets.[] Drill holes on the circles. If there is a stud, drill a YS' holefor wood screws. For holes that don't line up with a stud,drill a %" hole for toggle bolts.NOTE:DO NOTmount the plate at this time.10