Ilnstallat!onnstruct=onsBuilt-In Wall Oven27" (68.6 cm) modelsJKS10, JKP30, JKP35, JKP55, JKP70, JKP75,PK916, PK956, ZEK938, ZEK95830" (76.2 cm) modelsJTP30, JTP35, JTP55, JTP70, JTP75, PT916,PT920, PT956, PT960, ZET938, ZET958If you have questions, call 1.800.GE.CARES or visit our website at:ge.comBefore You BeginRead these instructions carefully and completely.• IMPORTANT-save theseinstructions for local inspector's use.• IMPORTANT-observe allgoverning codes and ordinances.• Note to Installer--Be sure to leave theseinstructions with the consumer.• Note to Consumer--Keep theseinstructions for future reference.• Proper installation is the responsibilityof the installer and product failure dueto improper installation is NOT coveredunder warranty.• NOTE--This appliance must be properlygrounded.• ATTENTION INSTALLERAll electric wall ovens must be hard wired(direct wired) into an approved junctionbox. A plug and receptacle is NOT permittedon these products.Parts Included(Appearance will vary)Screws For Installation(8-18 x .750 flat headPhillips wood screws)WB07T10578 - BlackWB07T10579 - SSOptional 27" (68.6 cm)Metal Bottom Trim Assembly(on some models or can bepurchased separately)27" (68.6 cm)Metal Bottom Trim30" (76.2 cm)Metal Bottom TrimAssemblyMaterials NeededStrain Relief Clamp Junctionfor 1/2" conduit BoxWire Nuts36" (91 cm)of StringTools Needed1/8" (3 mm) Drill Bit andElectric or Hand Drill PhillipsScrewdriver31-10647-3 11-07 JR