GE JK3800DH1BB Technical Service Manual

Also see for PT7800DH1BB: Installation instructions Owner's manual

Contents

GE JK3800DH1BB Technical Service Manual Manual pdf 68 page image

– 68 –Element Reinstallation1. Be careful that the wire terminals do not catchon the rear of the frame when reinstallingthe element. Be sure that the insulation isreassembled to prevent excessive heat leakage.2. Be sure to clear the lip when reinstalling. Theelement may have resistance when pushingthrough as it slides through the guides.3. Reinstall the two T20 Torx screws that securethe hidden bake compartment cover in place.4. Reinstall the insulation panels.5. At the front of the unit, replace the oven door(s)and reinstall the four or six T20 Torx screws(depending on whether the unit is single ordouble oven, upper or lower).6. Reinstall the wires from the bake terminals andthe T20 Torx screw securing the bake element tothe frame.7. Reinstall the rear wire cover.8. Safely replace the oven into the cabinetinstallation.9. Reconnect power to the oven.BroilBroil Elements Removal1. Remove one T20 Torx screw from the ovensensor, pull the wire through and disconnect.2. Remove the two T20 Torx screws on the backwall and the two T20 Torx screws from the frontsupport bracket.3. Pull forward and remove the wires.Broil Elements Reinstallation1. Reinstall the wires on the broil element, theninsert through the opening and secure.2. Reinstall the two T20 Torx screws on the backwall and the two T20 Torx screws to the frontsupport bracket.3. Reconnect the wire harness plug and pushthrough the broil opening and secure with oneT20 screw.