GE JGS905BEKBB Installation Instructions Manual

Contents

GE JGS905BEKBB Installation Instructions Manual Manual pdf 12 page image

12Installation InstructionsINSTALL THE RANGE (CONT.)COOKTOP BURNERSASSEMBLING THE BURNERSCAUTION: The electrode of thespark igniter is exposed. Be careful not tosnag the electrode of the spark igniter witha cleaning cloth. Damage to the igniter couldoccur. Be careful not to turn on any cooktopcontrols while cleaning. A slight electricalshock might result, which could cause youto knock over hot cookware.FOR GLASS CERAMIC COOKTOPSa. Place the burner head on the burner base,so that the pins match up with the slots onthe base.b. Position the burner cap on the burner head.c. Place the burner grate over the burnerassembly. The grates fit over the raisedarea on the burner head.A17 CHECK FOR LEAKSTurn the gas supply on and use a liquid leakdetector (soap solution) at all joints andconnections to check for leaks. Do not use anopen flame to look for leaks. Be sure all leaksare stopped before lighting burners.BPRESSURE TEST INFORMATIONThe maximum allowable supply pressurefor the regulator is 14″ W.C. The minimumsupply pressure needed to check the regulatorsetting is 7″ W.C. for natural gas and 10″ W.C.for LP gas.WARNING: The range and itsindividual shut-off valve must be disconnectedfrom the gas supply piping system during anypressure testing of the gas supply system attest pressures of more than 1/2 psig (poundsper square inch gauge). The range must beisolated from the gas supply piping systemby closing its individual shut-off valve duringany pressure testing of the gas supply systemat test pressures equal to or greater than1/2 psig. NOTE: 1/2 psig = 13.855″ w.c.CSparkigniterlocationBurnergrateBurnerbaseBurnercapBurnerheadSparkigniterGlassmaintopVentcover