Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.comLP Conversion Gas CooktopInstructions JGP985Adjustable wrenchPART QUANTITYBrass orifices 4Stick-on conversion label 1Small, thin-blade flat screwdriver with approximately 1/8″blade width is needed to access the calibration screw.49-802984226-0018-0001-05 JRPrinted in Korea1BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT – Save these instructions forlocal inspector’s use.• IMPORTANT – Observe all governing codesand ordinances.• Note to Installer – Be sure to leave these instructionswith the Consumer.• Note to Consumer – Keep these instructionsfor future reference.• This cooktop is factory set for natural gas operation.Conversion to LP operation should be performed by aqualified technician or installer. Keep these instructionsfor future reference. When converting to LP, save theoriginal parts for possible future use.• Product failure due to improper installation is not coveredunder the GE Appliance Warranty.FOR YOUR SAFETYWARNING – If you are using LP (bottled) gas,all adjustments described in the following steps must bemade before attempting burner adjustments or use of thecooktop.WARNING – This conversion kit shall beinstalled by a qualified service agency in accordance withthe manufacturer’s instructions and all applicable codesand requirements of the authority having jurisdiction.If the information in these instructions is not followedexactly, a fire, explosion or production of carbonmonoxide may result, causing property damage, personalinjury or loss of life. The qualified service agency isresponsible for the proper installation of this kit. Theinstallation is not proper and complete until the operationof the converted appliance is checked as specified in themanufacturer’s instructions supplied with the kit.TOOLS YOU WILL NEEDPARTS INCLUDED