GE JGB910 Technical Service Manual

Also see for Appliances Profile JGB920: Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions

Contents

GE JGB910 Technical Service Manual Manual pdf 11 page image

– 9 –Warming ZoneThe warming zone, located in the center of the glasscooktop, will keep hot, cooked food at serving tempera-ture.Remove Warming Zone Unit1. Remove electrical power to the range. Turn off gas atthe main valve.2. Raise the cooktop.3. Disconnect 4 wires from the front of the unit.4. Remove screws from 3 metal holding brackets at the12, 36, and 60 positions marked on the unit.5. Support the unit with one hand while easing back thebrackets with the other hand.NOTE: To access the infinite switch for the warmingzone, remove the lower control panel.Lower Control Panel AccessRemove Lower Control Panel1. Remove electrical power to the range. Turn off gas atthe main valve.2. Remove cooktop.3. Remove all knobs by pulling them straight off thestems.4. Remove 4 screws (A) beside rear burner knobs.5. Remove 2 screws (B) on top of lower control panel.6. Carefully pull panel over stems.NOTE: When the lower control panel is removed, wiresfor the warming drawer, warming zone, and burnerignition are accessible for repair.GEA00125AB BAB BGEA00338Temperature Limiter HeatingElementCollarFlat MetalCrimped "Ribbon"Zig Zag PatternSupport Tray forHeating Element