GE JGB870 Owner's Manual And Installation Instructions

Also see for Appliances CGS990: Technical service guide Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's manual

GE JGB870 Owner's Manual And Installation Instructions Manual pdf 33 page image

GEAppliances.comOven Air VentsNever block the vents (air openings)of therange. They provide the air inlet and outlet thatare necessary for the range to operate properlywith correct combustion.Air openings are located at the rear of thecooktop, at the top and bottom of the ovendoor, and at the bottom of the range.Vent appearance and location vary.Upper Control PanelOn models so equipped, lock out the touch padsbefore cleaning.See the Gas/Control Lockout information inthe Special features of your oven control sectionin this manual.Clean up splatters with a damp cloth.You may also use a glass cleaner.Remove heavier soil with warm soapy water.Do not use abrasives of any kind.Unlock the touch pads after cleaning.on _o8!_Surface burner knobUpper oven knob (on some models)holesLower Control Panel (Front Manifold Panell and KnobsIt's a good idea to wipe the control panel aftereach use of the oven. Use a damp cloth toclean or rinse. For cleaning, use mild soap andwater or a 50/50 solution of vinegar and water.For rinsing, use clean water. Polishdry with asoft cloth.Do not use abrasive cleansers, strong liquidcleaners, plastic scouring pads or oven cleanerson the control panel-they will damage thefinish.Do not try to bend knobs by pulling them upor down or by hanging a towel or other suchloads. This can damage the gas valve shaft.The control knobs may be removed for easiercleaning.Hake sure the knobs are in the OFF positionsand pull them straight off the stems forcleaning.Replace the knobs in the OFF position to ensureproper placement.Hetal parts can be cleaned with soap andwater. Do not use steel wool, abrasives,ammonia, acids or commercial oven cleaners.Dry with a soft cloth.To determine the correct location of the knobon the front control panel, examine the backof the knob. Knobswith labels and two stemholes are not interchangeable with othertypes of knobs and should be returned to thefront panel first. Locate the proper positionby matching the label and the front paneldescription or by matching the shape of theknob holes to the shape of the control panelstems. Knobswithout labels and only one stemhole can be returned to any position on thefront control panel that has only one stem.The knobs can be cleaned in a dishwasher orthey may also be washed with soap and water.Hake sure the insidesof the knobs are drybefore replacing.33