7Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Supportge.comOven Control, Clock and Timer Features and SettingsAUTOMATIC OVEN LightThis lights anytime the oven has beenprogrammed using the COOKING TIME orDELAY START functions.– PadShort taps to this pad will decrease the timeor temperature by small amounts. Touchand hold the pad to decrease the time ortemperature by larger amounts.+ PadShort taps to this pad will increase the timeor temperature by small amounts. Touchand hold the pad to increase the time ortemperature by larger amounts.SELF CLEAN PadTouch this pad to select the self-cleaningfunction. See the Using the self-cleaningoven section.CLEAN LightFlashes while in edit mode—you can changethe length of time for the self-clean cycle atthis point. Glows when the oven is in the self-clean cycle. After the self-clean cycle, the lightwill turn off. Unlatch the door.CLEAR/OFF PadTouch this pad to cancel ALL ovenoperations except the clock and timer.BROIL HI/LO PadTouch this pad to select the broil function.BROIL LightFlashes while in edit mode—you can switchfrom HI to LO BROIL at this point. Glows whenthe oven is in broil mode.Indicator Lights (on some pads)EDIT mode lasts several seconds after thelast pad press. DELAY START ON/OFF andCOOKING TIME ON/OFF will be the only padslit if either of these options is selected.(Example: DELAY START is selected withBAKE—the DELAY START pad will remainlit until the clock reaches the programmedtime, at which point it will turn off and theBAKE/TEMP RECALL pad light will light up).Power OutageIf a flashing time is in the display, you haveexperienced a power failure. Reset the clock.To reset the clock, touch the CLOCK pad.Enter the correct time of day by touchingthe + or – pads. Touch the START/ON pad.Control LockoutYour control will allow you to lock out the touchpads so they cannot be activated when touched.To lock/unlock the controls:Touch the + and – pads at the sametime for 3 seconds, until the displayshows LOC ON.To unlock the control, touch the +and – pads at the same time for 3seconds, until the display showsLOC OFF.When this feature is on and the touchpads are touched, the control will beepand the display will show LOC ON. The control lockout mode affects alltouch pads. No touch pads will workwhen this feature is activated. The adjustment will be retained inmemory after a power failure.CONTROL LOCK/UNLOCKPRESS + AND – AND HOLD FOR 3 SECONDS