GE HOME GENERATOR SYSTEM 12000 WATT Installation And Start-up Manual

Also see for 12000: Operator's manual Instructions for installation, use and maintenance

Contents

GE HOME GENERATOR SYSTEM 12000 WATT Installation And Start-up Manual Manual pdf 17 page image

17fault Detection systemThe generator may have to run for long periods of time withno operator present. For that reason, the system is equippedwith sensors that automatically shut down the generatorin the event of potentially damaging conditions, such aslow oil pressure, high temperature, over speed, and otherconditions. Refer to Fault Detection System in the operator’smanual for more detailed information.The owner will use the remote LED indicator to observethe status of the home generator system. The remote LEDwill turn on and off in a series of blinks if certain faults aredetected in the generator system. Consult with the ownerfor a convenient location. Locate the electrical box in anarea visible by the home owner such as near a garage dooropener or security control panel.to install the remote LeD indicator:1. Push the LED through the mounting plate fromthe front until it snaps in place. The LED ispolarity sensitive.2. Using provided 10 pin connector and installer-supplied minimum 18AWG wire, connect the remoteLED to the generator control board +LED and GNDconnection. Use wire nuts to attach wire to LED leads.3. Attach mounting plate to installer-suppliedelectrical box.utility circuit connection“240V Utility” leads must be routed in conduit. The“240V Utility” leads deliver power to the generator’s circuitboard, optional battery warmer and optional oil warmer. Thispower also charges the battery. When power on these leadsis lost, the generator will start.Using provided 2 pin connector plug and installer-suppliedminimum 300V, 14 AWG copper wire, connect each controlcircuit terminal in the generator to the two-amp fuseterminals in the automatic transfer switch.When making connections, obey wire type and torquespecifications printed on the circuit breaker and neutral/ground connector.ABtransfer switch communication(Units with ACCM II or later transfer switch only)Using #18 AWG twisted pair conductors, no greater than200 ft in length, connect Tx Rx and Tx Rx GND from thegenerator control panel (a) to the GND and T/R on thetransfer switch control board (B).Not forReproduction