5-8 D30 Line Distance Protection System GE Multilin5.2 PRODUCT SETUP 5 SETTINGS55.2PRODUCT SETUP 5.2.1 SECURITYa) SECURITY OVERVIEWThe following security features are available:• Password security — Basic security present in the default offering of the product• EnerVista security — Role-based access to various EnerVista software screens and configuration elements. The fea-ture is available in the default offering of the product and only in the EnerVista software.• CyberSentry security — Advanced security options available as a software option. When purchased, the options areautomatically enabled, and the default Password security and EnerVista security are disabled.Changing the password, or any other setting, does not take the relay out of service. The relay is taken out of service whena settings file is written to it.LOST PASSWORDIf all passwords are lost, recovery is possible by resetting the unit to default values. Note that the relay is reset to defaultvalues, not just the passwords.To reset the unit after a lost password:1. Email GE customer service at multilin.tech@ge.com with the serial number and using a recognizable corporate emailaccount. Customer service provides a code to reset the relay to the factory defaults.2. Enter the reset code on the front panel, under COMMANDS RELAY MAINTENANCE SERVICE COMMAND.3. Change the default password of ChangeMe1# as outlined in the Setting Up CyberSentry and Changing Default Pass-word section in the first chapter.PASSWORD REQUIREMENTSA user account requires an alpha-numeric password that meets the following requirements:• Password is case-sensitive• Password cannot contain the user account name or parts of the user account that exceed two consecutive characters• Password must be 6 to 20 characters in length• Password must contain characters from three of the following four categories:- English uppercase characters (A through Z)- English lowercase characters (a through z)- Base 10 digits (0 through 9)- Non-alphabetic characters (for example, ~, !, @, #, $,%, &)b) PASSWORD SECURITYPATH: SETTINGS PRODUCT SETUP SECURITYThe D30 supports password entry from a local or remote connection. SECURITYACCESS LEVEL:RestrictedRange: Restricted, Command, Setting,Factory Service (for factory use only)MESSAGE CHANGE LOCAL PASSWORDS See page 5–9.MESSAGE ACCESS SUPERVISION See page 5–10.MESSAGE DUAL PERMISSION SECURITY ACCESS See page 5–11.MESSAGE PASSWORD ACCESSEVENTS: DisabledRange: Disabled, Enabled
