GE CGP650SETSS Installation Instructions Manual

Also see for CGP650: Owner's manual Installation instructions Installation instructions Owner's manual Installation instructions

Contents

GE CGP650SETSS Installation Instructions Manual Manual pdf 1 page image

131-10808 (07-11 GE)BEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT — Save these instructionsfor local inspector’s use.• IMPORTANT — Observe all governingcodes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructions forfuture reference.• Product failure due to improper installation is notcovered under the Warranty.WARNING — This appliance must beproperly grounded.• IMPORTANT — Leak testing of theappliance shall be conducted according to themanufacturer’s instructions.• Proper installation is the responsibility of theinstaller and product failure due to improperinstallation is NOT covered under warranty.IN THE COMMONWEALTH OFMASSACHUSETTS:• This product must be installed by a licensedplumber or gas fitter.• When using ball-type gas shut-off valves, theyshall be the T-handle type.• A flexible gas connector, when used, must notexceed 3 feet.Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.comIn Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.caInstallation 36″ Sealed Gas CooktopInstructions PGP976, PGP986, CGP650FOR YOUR SAFETY:WARNING — If the information in thismanual is not followed exactly, a fire, explosionor gas leak may result causing property damage,personal injury or death.Do not store or use gasoline or other flammablevapors and liquids in the vicinity of this or anyother appliance!WHAT TO DO IF YOU SMELLGAS:• Do not try to light any appliance. Do not touchany electrical switch; do not use any phone inyour building.• Immediately call your gas supplier from aneighbor’s phone. Follow the gas supplier’sinstructions.• If you cannot reach your gas supplier, call thefire department.Installation and service must be performed bya qualified installer, service agency or the gassupplier.This cooktop has been certified by UL. You’ll findsafety precautions in your Owner’s Manual. Readthem carefully.• Installation of this cooktop must conform withlocal codes or in the absence of local codes withthe National Fuel Gas Code, ANSI Z223.1/NFPA54–Latest edition.• Be sure your cooktop is installed properly by aqualified installer or service technician.• To eliminate reaching over surface burners,cabinet storage above burner should be avoided.• Do not install the unit near an outside door orwhere a draft may affect its use.WARNING — Disconnect all electricalpower at the main circuit breakeror fuse box before installing.