Chapter 4: Basic operation26 TruVision DVR 30 User ManualNote: Make sure that there is video signal input. Otherwise the spot monitor will onlyshow a blank screen.Controlling the spot monitorPress and hold a numeric button for two seconds to display the correspondingcamera in full screen. Additionally, press and hold the SEQ button (on the front panelor remote control) to initiate sequence mode on the spot monitor. Alternatively, clickthe Monitor button on the mouse toolbar to toggle to the spot monitor function, andthen click the Sequence button to begin sequence, as shown in Figure 11 below.Figure 11: Spot monitor functionLogging onThe TVR 30 is shipped with a predefined user for the system administrator. Thedefault system administrator logon uses “admin” as a user name with a password of1234. You can modify the admin password but not the admin user name. GE Securityrecommends that you change the admin password once you have completed theinstallation and setup to protect against unauthorized access. The seven predefinedstandard users are labeled User1 to User7 with a default password of 4321 and level4 access. The administrator can customize these users and define their privileges. Formore information, see “Managing users” on page 47”.To log on to the TVR 30 user interface:1. Click Menu.2. Select a user in the Account field.3. Use the mouse or the Down Arrow button to select the Password field.4. Enter the corresponding password.5. Click Confirm to enter the main menu.
