GE 2PK REINDEER Instruction Manual
2PK REINDEERInstruction ManualIMPORTANT SAFETYINSTRUCTIONS:(a) READ AND FOLLOW ALLSAFETY INSTRUCTIONS(b) Do not cover this product as the covering may cause theflexible light to overheat and melt or ignite.(c) Do not operate with the flexible light tightly coiled.(d) Do not puncture, cut, shorten, or splice the flexible lighting.(e) Do not route the cord or flexible lighting through walls, doors,windows or any like part of the building structure.(f) “Do not use if there is any damage to the light or cord insulation.Inspect periodically.”(g) Do not submerge flexible light in liquids, or use the product inthe vicinity of standing water or other liquids.(h) Secure this flexible light using only the hangers or clipsprovided. Do not secure this product or its cord with staples,nails, or like means that may damage the insulation orpermanently attach to the building structure.(i) Do not subject flexible lighting to continuous flexing.(j) Do not install on gates or doors, where subject to flexing.(k) Do not install in cabinets, tanks or enclosures of any kind.(l) Do not mount or secure this product in a manner that can cutthe outer jacket or damage the cord insulation. Inspect thisflexible light carefully before use and discard any flexible lightthat have broken outer jacket, loose connections, or frayedwire insulation.(m) This product has a polarized plug (one blade is wider than theother) as a feature to reduce the risk of electric shock. This plugwill fit in a polarized outlet only one way. If the plug does not fitfully in the outlet, reverse the plug. If it still does not fit, contacta qualified electrician. Never use with an extension cord unlessplug can be fully inserted. Do not alter the plug.(n) Risk of fire. Do not replace attachment plug. Contains asafety device (fuse) that should not be removed. Discardproduct if the attachment plug is damaged.(o) Always unplug this product before installing or replacingfuses.(p) CAUTION – Risk of Electric Shock. Do not use withextension cord near water or where water may accumulate. Foruse only on GFCI protected circuits.(q) Material may become brittle when cold. Do not install where itmay be stepped on or subject to physical damage.WARNING: When using outdoor use portablelighting products, basic safety precautions should always befollowed to reduce the risk of fire, electric shock, and personalinjury, including the following:READ ALL INSTRUCTIONS(a) Ground Fault Circuit Interrupter (GFCI) protection should beprovided on the circuits or outlet to be used for the outdoor useflexible lighting product. Receptacles are available having built-in GFCI protection for this measure of safety.(b) Use only outdoor extension cords, such as type SW, SOW,STW, STOW, SJW, SJOW, SJTW, or SJTOW. This designationis marked on the wire of the extension cord.SAVE THESE INSTRUCTIONSTO REPLACE THE FUSE:This plug contains an electrical fuse a safety feature. Disconnect power before replacing the fuse. Grasp plug and remove from the receptacle or other outletdevice. Do not unplug by pulling on the cord. Unscrew the fuse access cover between blades of theattachment plug. Remove old fuse carefully. Never attempt to replace the fuse with a higher watt fuse rating.Use only 5 Amp 125Volt fuse. Failure to do so may cause riskof fire or damage to property. Carefully insert new fuse into the holder. Return and tighten threaded screw type fuse cover in place.INSTALLATION INSTRUCTIONS:1. Determine your desired location.2. Carefully assemble sculpture in place. See Assembly Manual provided.3. Secure sculpture footing using the 4 ground stakes provided.Item No.: FCB-XM-3D-MK0292-120V-WElectrical Rating: 120V, 60Hz, 17.1W, 0.15ASize: 31 inchesOperating Temperature: -5℉to 95℉ (-20℃ to 35℃)Application: Indoor and Outdoor UseItem No.: FCB-XM-3D-MK0251-120V-WElectrical Ratings: 120V, 60Hz, 18.8W, 0.17ASize: 48 inchesOperating Temperature: -5℉ to 95℉ (-20℃ to 35℃)Application: For Indoor and Outdoor UseFor questions and/or assistance, call customer service at 1-877-398-7337or visit us on the web at www.geholidaylighting.comPRINTED IN CHINA TF-17 MADE IN CHINA©2017 Nicolas Holiday Inc., 9F., No. 37, Guangfu N. Rd. Taipei, Taiwan 10560.All rights reserved. |
Related manuals for GE 2PK REINDEER
GE Criterion Instructions Manual
GE 10113 Installation Instructions Manual
GE FCB-XM-3D-MK0292-120V Instruction Manual
GE 72612LO Assembly Instructions Manual
GE FCB-XM-3D-CH0078-120V Instruction Manual
GE LED 100L C9 Assembly Instructions Manual
GE Evolve E2SA Installation Manual
GE Lumination LHSHX Installation Manual
GE Lumination EP24 Series Installation Manual
GE Arize Element Series Installation Manual
This manual is suitable for:
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved