1Dhyyhv DpvB@Trpv9Product SummaryThe siren combines speaker and piezo technologythat produces a high-volume, low-current siren. Abuilt-in tamper switch detects cover and/or sirenremoval. Mounting hardware and a cover screw areincluded.InstallationInstallation involves mounting, wiring, and testing.Installation Guidelines• Mount siren where occupants can hear it. Morethan one siren may be required to cover all areas.• Make sure wire run from control panel to siren hascorrect number of conductors to provide fordesired functions. For example, to use all sirenfunctions (Steady, Warble, and Tamper), wire runmust have five conductors.• For control panels with only one siren output, usesiren terminal #1 (Steady).• When connecting siren Tamper to control panelzone input, install correct end-of-line (EOL) resis-tor (included with control panel) at siren terminals.• Figure 1 shows siren with cover removed.Figure 1. Siren Components and Mounting HolesMounting1. Select location for siren.2. Run appropriate conductor wire from control panelto siren location.3. Remove cover from siren.4. Hold siren on wall at mounting location and markdesired mounting holes. If using wall tamper fea-ture, be sure to mark wall tamper mounting hole.5. Install plastic anchors (included) where studs arenot present.6. Insert wire through wire feed hole on siren.7. Secure siren to wall with screws (included) atmarked locations.Wiring1. Connect positive (+) siren outputs from controlpanel to siren terminals #1 (Steady) and #2 (War-ble). For control panels with only one siren output,use #1 (Steady) terminal.2. Connect control panel ground (-) to GND siren ter-minal.3. Connect wiring from control panel zone input tosiren tamper terminals marked SW. Be sure to con-nect EOL resistor in series with one of the termi-nals.4. Place cover on siren and secure on bottom usingsmall flat head cover screw (included).TestingCaution!Contact central monitoring station before testing the siren.Testing requires causing alarms to verify correct siren oper-ation.1. Contact central monitoring station and informthem you are testing the system.2. Activate intrusion and fire alarms to verify sirenoperation.3. Arm system and remove siren cover to verifytamper circuit works.4. Replace siren cover.5. Contact central monitoring station when you arefinished testing.Mounting HolesMounting HolesWallTamperMountingHoleCoverTamperSW SW GND #2 #1WireFeedHoleChqvrDrvTvrDocument No. 466-2115 Rev. AJanuary 2004

GE 13-949 Installation Instructions Manual

Product

Learn More

Legal