GBC WireBind W15 Instruction Manual

Also see for GBC WireBind W15: Instruction manual

Contents

specifications

GBC WireBind W15 Instruction Manual Manual pdf 4 page image

Special noticeThank you for choosing a GBC Binding Machine. We aim toproduce quality binding machines at an affordable price, withmany advanced features to enable you to create excellentresults every time. Before using your machine for the first time,please take a few minutes to read through this guide.SpecificationsGBC WireBind W1515 sheets (80 gsm)1 sheet PVC Plastic Cover (0.18mm)DIN A4 (297mm)34 loop wire Binding125 sheets14mm7.3kg400mmx330mmx130mmMax Punch CapacityMax Punch CapacityMax Document SizePunching PatternMax Bind CapacityMax Wire SizeNet WeightDimensions (LxWxH)Safety instructionsYOUR SAFETY AS WELL AS THE SAFETY OF OTHERS ISIMPORTANT TO ACCO BRANDS EUROPE. IN THIS INSTRUCTIONMANUAL AND ON THE PRODUCT ARE IMPORTANT SAFETYMESSAGES. READ THESE MESSAGES CAREFULLY.mGeneral safeguards• Please read the instructions and keep them safe for futurereference.• When using the machine, always ensure the machine is on aflat and stable surface.• Keep out of reach the reach of children at all times.• Do not tamper in any way with the internal mechanisms ofthis machine.• Do not immerse in liquid.• Test the punching system with a scrap piece of paper first.• Take care that there are no staples or such like in thedocument prior to punching.• Do not place anything in the punching entry other than paperup to 15 sheets (80gsm) or one PVC plastic cover up to0.18mm.• Only carry the machine using the carry handle, never thepunching arm.• Empty the clippings tray regularly.Setting up1 The handle needs to be installed onto the shaft to the rightof the machine. Slot the handle onto the shaft and securewith the screw.2 Retain the packaging in case you need to return themachine for repair. Place on a secure, stable surface.3 The punching mechanism is coated with a protective film,which will mark your paper. To clear this, punch scrapsheets of paper until clean prior to punching.Punching the document1 Lift the lid and punch handle to the upright position. Insertthe document into the punch throat, maximum 15 sheets ata time. Jog the sheets until they are flush against the paperstop. (see fig 1)Important: Always set the wire closure control to thePunch Point setting during punching. (see fig 1a)2 Pull the punch handle towards you until all papers havebeen punched. (See fig 2) Then, return the punch handle toits original position and remove the paper from the punchthroat. Repeat this operation until all papers have beenpunched.Important: If punching PVC covers, insert no more thanone cover at a time as this material, in large quantities,could cause jams or excessive wear. It is recommended topunch PVC cover along with 1 sheet of normal paper. Thiswill allow better punching holes quality.