GAS GAS FSE 450 Service Manual

Also see for 2005 FSE 450: Workshop manual MANUALE D'OFFICINA

GAS GAS FSE 450 Service Manual Manual pdf 41 page image

-39-Cleaning1- Preparation for cleaningBefore cleaning the motorcycle must be prepared so that water doesnot penetrate certain areas of the bike.The exhaust: Once this is cold, cover it with a plastic bag attachedwith rubber.Clutch and brake levers, grips and stop button: cover with aplastic bag.Air filter intake: cover this with insulation tape or a cloth.2- Where to be carefulAvoid spraying water with any great force near the followingplaces: Disc brake master cylinders and callipers; under the fueltank (If water gets into the ignition coil or into the spark plug cap, thespark will jump through the water and be grounded out; the affectedparts must be dried).Front and rear hubs.Steering pivots (steering tube).Rear suspension system.Swing arm pivots.3- After cleaning- Remove the plastic bags and clean the air filter intake.- Lubricate the locations listed in the lubrication section.- Start the engine and let it heat for 5 minutes.- Check the brakes before driving the bike.WARNINGNever wax or lubricate the brake disk, this could lead to brake failureand could provoke an accident. Clean the disk using trichloroethyleneor acetone.