GAS GAS EC 125 - 2003 Service Manual

Also see for 2005 ENDUCROSS EC 125: Service manual User manual Service manual Parts list Parts list

GAS GAS EC 125 - 2003 Service Manual Manual pdf 16 page image

EC 2003 -78-- If the marks are not aligned, loosen the magneto stator screwsand turn the magneto stator.- Tighten the screws securely.- Install the magneto cover.NOTEThe ignition timing can be adjusted for different power and tosuit the rider´s preference and ability.- Remove the magneto cover.- Loosen the stator screws.- Adjust the timing by shifting the stator position within the threelines.NOTEFor the best engine performance, it is very important to adjustthe ignition timing within the adjustable range just explained.- Tighten the stator screws securely.- Install the magneto cover.- Test ride the motorcycle and readjust the ignition timing if necessary.COOLING SYSTEMRadiator HosesCheck the radiator hoses for cracks or deterioration, and connectionsfor looseness in acordance with the Periodic Maintenance Chart.RadiatorCheck the radiator fins for obstruction by insects or mud. Clean offany obstructions with a stream of lowpressure water.IGNITION TIMINGBecause a capacitor discharge ignition (CDI) system is used on thismotorcycle, the ignition timing should never require adjustmentunless the magneto stator is incorrectly installed during enginereassembly. However, if there is any doubt as to the timing, inspectand adjust, if necessary, as follows:Ignition Timing Adjustment- Remove the magneto cover (A).- Check to see if the center mark of the three marks on the magnetostator (C) is aligned with the mark on the crankcase (B).125 cc.200/250/300 cc.(B)(C)(A)