Fujitsu UTY-DCGYZ3 Operation Manual

En-473-5-8. Mail SettingSets the mail address destination when “Error notification” or “Room temperature notification” is sent.(1) Tap the MENU button.(2) Tap the [Installer Setting].(3) Tap the [Mail Setting].(4) Select the setting function.No. Item Description “Mail Setting” Performs the mail account setting, etc.→Refer to 3-5-8-1. “ServerSetting”Performs the mail server connectionsetting.→Refer to 3-5-8-2.* After the Server Setting is performed, perform the Mailsetting.3-5-8-1. Mail Setting(1) Set the item and tap the [OK] button.No. Item Description “Errornotification”Sets “Enable” or “Disable” of mailnotification when an error occurs. “Email Address”Sets the mail address destinationwhen “Error notification” or “Roomtemperature notification” is sent.3 “TransmissionTest”Performs “Transmission test” to sendthe notification mail.Transmission result display:“Failed sending mail.”(*1) / “Mail sent.”4“Roomtemperaturenotification”(“Lower Limit”)(*2)Sets the room temperature lower limitfor sending a mail.“Lower limit”: -15.5ºC5“Roomtemperaturenotification”(“Upper Limit”)(*2)Sets the room temperature upper limitfor sending a mail.“Upper limit”: 63.5ºC(*1) If sending mail is failed, the failure reason of sending isdisplayed. When a mail server error is displayed in failurereason message, contact the mail server managementcompany. For other messages, check the appropriatesettings in this controller.(*2) For room temperature notification, wired remote controllermust be connected to the indoor unit and remote sensormust be enabled.For the setting method, refer to the remote controllermanual.* If the server setting is not correct, mail is not sent. For details,refer to your mail service.(2)(3)(1)4 533