Fujitsu SPARC Enterprise T2000 Getting Started Manual

Also see for SPARC Enterprise T2000: Service manual Getting started guide Administration guide Product notes Installation guide

Contents

before you begin

This guide describes the minimum steps you must perform to power on and boot your server for the first timeusing the preinstalled Solaris™ Operating System (Solaris OS).FIGURE 1 SPARC Enterprise T2000 ServerShipping ContentsBefore You BeginFor quick installation and configuration, follow these steps. For more detailed information, refer to the completeonline product documentation set at: http://www.fujitsu.com/sparcenterprise/manual/Understand the following information before you set up the server for the first time:■ Do not apply power until instructed to do so – This system includes a system controller (SC) that is used toconfigure and boot the host server. To properly configure the host server and view SC messages, do not applyAC power to the server until the SC and host networking connections are made, as described in this guide.■ Choose the best instructions for your situation – The quick setup instructions in this guide work for anynetworking environment, and require the use of a terminal device for connection to a serial port. If you havea networking environment running DHCP, you can configure your system using the Ethernet managementport. To take advantage of the DHCP setup method, refer to the online installation guide in the online productdocumentation set at: http://www.fujitsu.com/sparcenterprise/manual/Quantity Item1 Server1 Rackmounting kit with cablemanagement assembly2 RJ-45 Ethernet cable1 RJ-45 to DB-25 adapter (crossover)1 RJ-45 to DB-9 adapter (crossover)1 Wrist strap2 Power cords (packaged separately)SPARC ® Enterprise T2000 Server Getting Started Guide