Menu
Fujitsu SMARTCASE S520 Assembly Instructions Manual
Also see for D3654-B: Short description
            |
Assembly Instructions SMARTCASE S520__________________________________________________________________________________________________________________________________________________________Page 5 of 12 V1.1 - 07/2019 www.fujitsu.comWLAN module / M.2. module assemblyFirst remove the M.2 mounting screws.Insert M.2 modules angular into the socket (while paying attention to the coding / notch).Both modules, as shown in the picture, have to be touched on the outside edges only.For the M.2 Key M SSD and M.2 Key E WLAN/BT, the assembly nuts and screws are pre-installed.Recommended torque for the M.2 screw is 0.2Nm, and 0.3Nm for the nut.Processor assemblyFirst open the CPU socket and remove the socket protection. Then insert the CPU. Consider the mechanical coding ofthe CPU. After installing the CPU close the socket carefully.Pay attentionto the notch2230 screw / nutposition2280 screw /nut position |
Related manuals for Fujitsu D3654-B
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved