Fujitsu MBA3073NC Product Manual

Also see for MBA3073NC: Specification Product manual Installation guide Installation guide

Contents

5.3 Setting TerminalsA user sets up the following terminals and SCSI terminating resistor before installing the HDD inthe system as required.• Setting terminal: CN1 (NC model), CN2 (NP model)Figure 5.2 shows the location of the setting terminal for NP model, and Figure 5.3 shows theallocation and the default settings for NP model. See Figure 4.13 and Table B for NC modelbecause the setting terminal is included in SCSI connector (CN1).CAUTIONData loss1. The user must not change the setting of terminals not described in thissection. Do not change setting status set at factory shipment.2. Do not change the setting of terminals except following setting pinsduring the power is turned on.• Write protect: Pin pair 9/10 of the CN2 setting terminal (NP model only)3. To short the setting terminal, use the short plug attached when the deviceis shipped from the factory.Pin 1 Pin 23Pin 24CN2Pin 2Figure 5.2 Setting terminals location (on NP models only)C141-E270 75