4.1 Mode ParametersC141-E167 4 - 1300b= Perform disconnection according to the instructions of other parameters withoutusing DTDC.01b= When a data transfer by the command is started, the target will never trydisconnection until transmission of all the data to be transferred by the commandis completed. The specified values in the "connect limit time" and "bus inactivitylimit" fields are ignored during the data transfer.10b= Reserved.11b= When a data transfer by the command is started, the target will never trydisconnection until execution of the command is completed. The specifiedvalues in the "connect limit time" and "bus inactivity limit" fields are ignoredduring the data tranfer.h. Disconnect Immediate (DImm) (Not supported)The IDD always control disconnection with itself algorithm. Therefore, The IDD disregards thevalue specified in this parameter, and operates according to the "Default" value."0" : The IDD transfers data for a command during the same interconnect tenancy in which itreceives the command. Whether or not the target does so may depend upon the target'sinternal algorithms, the rules of the applicable SCSI protocol, and settings of the otherparameters in this mode page."1" : The IDD does not transfer data for a command during the same interconnect tenancy inwhich it receives the command.i. Fair arbitrationThis field indicates whether the target uses fair or unfair arbitration when requesting aninterconnect tenancy."000b" : Cannot use the arbitration fairness during a normal arbitration.except above : Can use the arbitration fairness during a normal arbitration.j. Enable modify data pointer (EMDP) (Not supported)This bit indicates whether or not the initiator allows the data transfer to be re-ordered by thetarget.The IDD are not supported a MODIFY DATA POINTER message. Therefore, The IDDdisregards the value specified in this bit, and operates according to the "Default" value."0" : The IDD cannot transfer a MODIFY DATA POINTER message."1" : The IDD can transfer a MODIFY DATA POINTER message.
