Menu
Fujitsu M255XK Customer Engineering Manual
                                                                                              |
4.4.2 Bail inspection and AdjustmentTools Required: Phillips Screwdriver, M3Screw Lock AdhesiveRefer to Figures 4-4 and 4-5.1. Open the Front Lever so a disk can be inserted.2. Check the gap between the bail assembly and the Spindle Motor. If the gap isnot 0.35" (9mm) turn the bail assembly adjustment screw to adjust the gap.3. Check that the upper arm does not contact the bail when the front lever isclosed (clamped). .4. Slowly insert a disk .andensure there is sufficient clearance for the disk to beinserted without the jacket contacting either read/write head.5. Repeat inserting and ejecting the disk 2 or 3 times to be certain the ejectclamp operation is smooth.6. Check for sufficient clearance for the diskette to be inserted/ejected withoutthe head window (the opening in the disk jacket through which the read/writeheads contact the disk surface) catching. on either read/write head.7. Coat the adjustment screw with Screw Lock Adhesive and fasten the bail.8&11------,Adjustment screwTS-021-013087 ••• 01r--------- Am lifterr------- Upper arIDViewed from the Front Bezel SideFigure 4-4 Bail Height Adjustment4-10Disk Drive motorplate edge |
Related manuals for Fujitsu M255XK
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved