166FCC Radio Frequency Exposure statementThe available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is noproof, however, that these low power wireless devices are absolutely safe. Low power wireless devices emit low levels of radio frequencyenergy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure tolow-level RF that does not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposure have notfound any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not beenconfirmed by additional research.The wireless LAN radio device has been tested and found to comply with FCC radiation exposure limits set forth for an uncontrolledequipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65.Export restrictionsThis product or software contains encryption code which may not be exported or transferred from the US or Canada withoutan approved US Department of Commerce export license. This device complies with Part 15 of FCC Rules., as well as ICES003 B / NMB 003 B. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesirable operation.Modifications not expressly authorized by Fujitsu America, Inc. may invalidate the user's right to operate this equipment.Canadian NoticeThe device for the 5150 - 5250 MHz band is only for indoor usage to reduce the potential for harmful interference to co-channelmobile satellite systems.The maximum antenna gain of 6 dBi permitted (for devices in the 5250 - 5350 MHz, 5470 - 5725 MHz and 5725 - 5825 MHzbands) to comply with the e.i r.p. limit as stated in A9.2 of RSS210.In addition, users are cautioned to take note that high power radars are allocated as primary users (meaning they have priority)of 5250 - 5350 MHz and 5650 - 5850 MHz and these radars could cause interference and/or damage to LE-LAN devices.
