SERVIS IP-Serial1p ConverterUser's Guide333 Function DetailsProcedureThe following explanation uses an example scenario when accessing the target port(read/write) with a telnet connection.1. Power on the terminal PC on the network, and then execute the telnetconnection from the emulator application. (Assume the IP address of"192.168.0.50" has been pre-assigned to this product.) Specify port number30003 (read/write).2. This establishes a connection to the target port. In this state, input and outputdata to and from the serial device can be monitored.3. After finishing monitoring/configuring the connected device, disconnect thecommunication.When connecting using an emulator application such as TeraTerm, select"Disconnect" or "Exit" from the drop-down menu.When connecting via the command line from a UNIX host, etc., enter the telnetescape code "~]" and type "quit" to exit.If a connection cannot be established, check the IP address and target portsettings of this product.Since a connection to the above TCP ports (30003, 30002, 30001, and 30000)is exclusive, simultaneous instances cannot exist.Connection/disconnection information of Ether-direct is stored in the clog(connection log) file.During an Ether-direct connection, target port logs are not stored.C:\temp> telnet 192.168.0.50 30003 Enter
