Chapter 2 Components2.1 3.5" Type Controller EnclosureETERNUS DX60/DX80/DX90 Disk storage system User Guide54Copyright 2011 FUJITSU LIMITED P3AM-3042-08ENZ0● ETERNUS DX60/DX80 iSCSI modelFigure 2.8 shows the ETERNUS DX60/DX80 iSCSI model controller.Figure 2.8 ETERNUS DX60/DX80 iSCSI model controlleriSCSI port (1000Base-T) (0 (left),1 (right))RJ45 connectors for LAN cablesFAULT LEDGlows orange ( ) during the post power oninitialization phase. Also glows orange ( ) toindicate an iSCSI port failure has been detected.SCU STATUS LEDGlows green ( ) when SCU is normal.Blinks green ( ) when being charged(for about one minute after the device power is turned on).IDENTIFY LEDBlinks blue ( ) or turns off ( ) as ordered via GUI toidentify the enclosure installation locations.SAS (DE) LINKUP LEDGlows green( ) when link has been established.LAN port (1000Base-T/100Base-TX/10Base-T)(RMT port (left), MNT port (right))RJ45 connectors for LAN cablesEach controller has two such ports.UNIT READY/FAULT LEDGlows green ( ) during normal operation.Glows orange ( ) during the post power oninitialization phase. Also glows orange ( ) toindicate a fault has been detected.MASTER LEDGlows green ( ) when the controller is setas the Master CM.LINK LEDGlows green ( ) when link has been established.LINK LEDGlows green ( ) when link has been established.ACT LEDGlows green ( ) when data is being sent and received.PWC portThis is not used.SAS (OUT) portConnector for a miniSAS cableUsed to connect the Controller Enclosure to a Drive Enclosure.
