Fujitsu ETERNUS LT260 User Manual

Also see for ETERNUS LT260: User guide User guide User guide Quick start guide

Contents

Chapter 2 Operating the Library2.5 Configuring the LibraryFUJITSU Storage ETERNUS LT260 Tape Library User’s Guide -Panel Operation-Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0454 Select whether to report the barcode characters from the left or right end of the barcodelabel to the host application when reporting fewer than the maximum number of charac-ters.For example, when reporting only six characters of the barcode label 12345678, if alignment is left, thedevice will report 123456. If alignment is right, the device will report 345678. The default is left.5 Click the check box of "Auto Clean" if you enable the drive auto cleaning function on theselected partition.6 Click Next.7 In the Assign Storage Slots screen, use the >> and << buttons to assign slots to the new par-tition and then click Next.8 In the Assign Mail Slots screen, use the >> and << buttons to assign mailslots to the newpartition and then click Next.Individual mailslot elements cannot be shared between partitions. Importing or exporting cartridges ina partition without an assigned mailslot will require magazine access, which will take the library offline.9 In the Assign Drives screen, use the >> and << buttons to assign drives to the new partitionand then click Next.10 If the partition has multiple tape drives, select the drive that will host the SCSI communica-tion for the partition and then click Next.The lowest numbered drive in the partition is the default.11 Verify the partition configuration and then click Finish.After the wizard reconfigures the partition, the library will come on line automatically.End of procedure■ To remove a partitionProcedure1 Select the partition, click Remove, and then click Next.2 Verify that you want to remove the partition and then click Finish.After the wizard removes the partition, the library will come on line automatically.End of procedure