Fujitsu ETERNUS AB Series Maintaining Hardware

Also see for ETERNUS AB Series: Hardware maintenance guide Site planning guide

| Controllers |Note: If the original controller did not use DHCP for the IP address, the new controller will adopt the IPaddress of the controller you removed.What to do nextGo to Complete controller replacement (duplex).Complete controller replacement (duplex)You complete the controller replacement by placing the controller online and confirming that the storagearray is working correctly. Then, you can collect support data and resume operations.Procedure1. As the controller boots, check the controller LEDs and the seven-segment display.When communication with the other controller is reestablished:• The seven-segment display shows the repeating sequence OS, OL, blank to indicate that thecontroller is offline.• The amber Attention LED remains on.• The Host Link LEDs might be on, blinking, or off, depending on the host interface.Host Link LEDs Attention LED (Amber) Seven-segment display2. Check the codes on the controller's seven-segment display as it comes back online. If the display showsone of the following repeating sequences, immediately remove the controller.• OE, L0, blank (mismatched controllers)• OE, L6, blank (unsupported HIC)Attention: Possible loss of data access – If the controller you just installed shows one thesecodes, and the other controller is reset for any reason, the second controller also could lock down.3. When the controller is back online, confirm that its status is Optimal and check the controller shelf’sAttention LEDs.If the status is not Optimal or if any of the Attention LEDs are on, confirm that all cables are correctlyseated and the controller canister is installed correctly. If necessary, remove and reinstall the controllercanister.Note: If you cannot resolve the problem, contact technical support.4. If required, redistribute all volumes back to their preferred owner.a) Select Storage > Volumes.b) Select More > Redistribute volumes.5. Click Hardware > Support > Upgrade Center to ensure that the latest version of SANtricity OS software(controller firmware) is installed.As needed, install the latest version.6. Collect support data for your storage array using SANtricity System Manager.a. Select Support > Support Center > Diagnostics.26