C141-E090-01EN5 - 36At command issuance (I/O registers setting contents)1F7H(CM) 1 1 1 0 1 1 1 11F6H(DH) × × × DV xx1F5H(CH)1F4H(CL)1F3H(SN)1F2H(SC)1F1H(FR)xxxxxxxx or transfer mode[See Table 5.6]At command completion (I/O registers contents to be read)1F7H(ST) Status information1F6H(DH) × × × DV xx1F5H(CH)1F4H(CL)1F3H(SN)1F2H(SC)1F1H(ER)xxxxxxxxError informationThe host sets X'03' to the Features register. By issuing this command with setting a value tothe Sector Count register, the transfer mode can be selected. Upper 5 bits of the Sector Countregister defines the transfer type and lower 3 bits specifies the binary mode value.However, the IDD can operate with the PIO transfer mode 4 and multiword DMA transfermode 2 regardless of reception of the SET FEATURES command for transfer mode setting.The IDD supports following values in the Sector Count register value. If other value thanbelow is specified, an ABORTED COMMAND error is posted.PIO default transfer mode 00000 000 (X‘00’)PIO flow control transfer mode X 00001 000 (X‘08’: Mode 0)00001 001 (X‘09’: Mode 1)00001 010 (X‘0A’: Mode 2)00001 011 (X‘0B’: Mode 3)00001 100 (X‘0C’: Mode 4)Multiword DMA transfer mode X 00100 000 (X‘20’: Mode 0)00100 001 (X‘21’: Mode 1)00100 010 (X‘22’: Mode 2)Ultra DMA transfer mode X 01000 000 (X‘40’: Mode 0)01000 001 (X‘41’: Mode 1)01000 010 (X‘42’: Mode 2)01000 011 (X‘43’: Mode 3)01000 100 (X‘44’: Mode 4)
