Fujitsu A6110 - LifeBook - Core 2 Duo 2.2 GHz Getting Started Manual

Also see for A6110 - LifeBook - Core 2 Duo 2.2 GHz: Bios guide User guide User guide User guide

Contents

getting started

CautionWall JackThe Lithium ion battery is not charged upon purchase.Initially you will need to connect either the AC adapteror the Auto/Airline adapter to use your notebook.Be careful when you select the language.The only way to change the languageis to do a recovery process.Quick TipsIt takes approximately 4 hours tocharge a fully discharged singlebattery with unit off or insuspend mode.Optimizing Battery Life• Set power management settingto Maximize Battery Life.• Adjust display brightness levelsto lowest comfortable setting.• Remove PC Cards and Express-Cards when not needed.• Utilize Suspend mode whennot using your notebook.• Read the Power Managementsection in your electronic User’sGuide for additional features.Adjusting Display Brightness• Fn + F6 to decrease brightness• Fn + F7 to increase brightnessAdjusting Volume• Fn + F8 to decrease volume• Fn + F9 to increase volume* Mono microphone jack or stereomicrophone/line in jack dependingon configuration.* * Stereo headphone/Optical DigitalAudio out jack or stereo head-phone/Line Out/Optical DigitalAudio out jack.Caution: Your system isconfigured with TrustedPlatform Module (TPM)Before you activate TPM, be sureyou fully understand how it worksby following the directions includedon the TPM applications CD. If youchoose to enable TPM, your TPMpassword will be critical to theoperation of your computer andMUST be remembered.DriversLook for the latest drivers on theDrivers and Applications RestoreCD. Right-click the FDU icon andselect “update”, or downloadthem at us.fujitsu.com/computers.This convenient guide will lead you through the start-upprocess and will also offer some valuable tips.1. Open the Display PanelEnsure that your LifeBook is on a hard level surface and that•the air vents are not blocked.Lift the display, being careful not to touch the screen.•Adjust the display until it is at a comfortable viewing angle.•2. Connect AC PowerPlug the AC adapter into your notebook.•Plug the power cord into the AC adapter.•Connect the power cord to an electrical outlet.•3. Connect to Internet or NetworkConnect either a phone cord to the modem jack or an Ethernet•cable to the LAN jack on your notebook and to a wall jackor to an Ethernet router.Important:During the setup procedure, do not disconnect the power supply,•press any buttons, or use any peripheral devices such as aremote control.• You should not attach any external devices and do not put a DVD/CD inyour drive until you have gone through the initial power on sequence.4. Booting the SystemPress the Suspend/Resume/Power button (above the keyboard) to turn•on the notebook. When you do this for the first time, it will display aFujitsu logo on the screen. If you do nothing the system will loadthe operating system, and then the Windows Welcome will begin.5. RegisterFor Genuine Microsoft ® Windows ® XP:After the operating system has initialized, enter the information•as prompted to personalize your notebook and configure yourmodem to dial.For Genuine Windows Vista®:Accept the Microsoft• ® Windows ® Licensing Agreement and theFujitsu End User License Agreement to proceed.Select your User ID and Password during the “Welcome Screen.”•• Keep a record of your User ID and password stored in a secure place.• THE SCREEN WILL GO DARK FOR APPROXIMATELY TWO MINUTES.Do not attempt to turn power on or off during this stage.•6. Registering Your LifeBook notebookRegister your notebook with Fujitsu Service and Support via our•Web site at us.fujitsu.com/computers.You will need to be set up with an Internet Service Provider (ISP)•to register online.7. Installing Click Me!Check to be sure the WLAN switch is on.•For Genuine Microsoft ® Windows ® XP: The first time you boot upyour system, you will see an icon called Click Me! in the Start menu.For Genuine Windows Vista®: In addition to an icon on thedesktop, a dialog box will automatically open that prompts youto run Click Me!. If you choose not run ClickMe! at this time,the ClickMe! icon will appear on your desktop.When you click the Click Me! icon, your system will automatically•build the icon tray in the bottom right of the screen. These iconsprovide links to utilities that you will frequently access.LEFT PANEL BOTTOM PANELRIGHT PANEL BACK PANELCLICK ME“Click Me!”ForAdditionalUtilitiesFujitsuDriverUtility IconInitial Start UpWhat’s in the BoxCheck to see that all of the following items are in the box:❏ LifeBook notebook ❏ International Limited Warranty ❏ Genuine Windows Vista® recovery❏ Lithium ion battery, pre-installed and Registration booklet and utility disc❏ AC adapter with power cord and core ❏ Microsoft® associated product materials ❏ Genuine Windows® XP Professional❏ Phone/modem (RJ-11) telephone cable ❏ Microsoft® application CDs recovery disc (For Genuine Windows❏ Drivers and Applications Restore (DAR) disc ❏ End User License Agreement Vista® Business Operating System)❏ User’s GuideDepending upon your configuration, the following items may also be shipped with your notebook:❏ Roxio Easy Media Creator, CyberLink ❏ Webcam Software discPowerDVD disc (See Readme file on ❏ Remote Control, Remote Control manual, batteries, anddisc for installation instructions.) USB IR receiver (for Genuine Windows Vista® Home❏ CyberLink PowerProducer, Premium operating system onlyPowerDirector disc ❏ Stylus in pen garage (with Point and Write Pad only)❏ CyberLink MakeDVD disc (Only with Genuine ) ❏ ExpressCard Hybrid (Digital/Analog) TV TunerWindows Vista® Home Premium) (For Genuine Windows Vista® Home Premium❏ Additional Lithium ion battery operating system onlyDC-InJack8. Install Additional SoftwareClose any open programs, applications or utilities•Insert software application CD into media drive.Open the application folder, select the set-up icon,•and load desired software, as shown in the table.Restart your computer.•Start your computer and insert the Recovery CD into the optical drive.•The Fujitsu Installer should automatically launch. If it doesn’t, you will•need to find the Setup.exe file on the Recovery CD’s root folder.If you are using Genuine Windows Vista®, Click [Allow] in the•User Account Control (UAC) box.Click [Continue]•Select “I Agree” and click [Continue] in the License Agreement box.•Select “User’s Guide” from the “Utilities/Applications” category.•Click [Install Selected Subsystems]•The User’s Guide will be copied to your hard drive in the•C:\Fujitsu\Manual directory. Shortcuts to the Users Guidewill be placed on your desktop and in the Start menu.9. Access your User’s GuideTo take advantage of all the features of your new Fujitsu LifeBook•notebook, it is highly recommended that you read your electronicUser’s Guide. It contains important detailed information aboutyour new computer. You can access your User’s Guide bydownloading it from the DAR disc, or from the support website.10. If you have a TV TunerSee the TV Tuner User’s Guide for installation•and setup procedures.Power/Suspend/ResumeButtonExpressCard Eject Button ExpressCard SlotPC Card Eject ButtonOptical Drive Release ButtonEmergency Optical Tray ReleaseOptical DrivePC Card Slot IEEE 1394 PortUSB PortWLANSwitchDisplayPanelLatchButtonACAdapterDC PowerJackIf you have a: You will need to installthe following software:Webcam Arcsoft WebCamCompanionDual-Layer Multi-Format CyberLink PowerProducerDVD WriterTelephone JackPower IndicatorThe Power indicator glows blue whenyour system is turned on.Battery Charge/DC-In IndicatorOrange, solid: AC adapter and batteryare available and system is charging.Green, solid: AC adapter and batteryare available and system is fullycharged, or AC adapter is pluggedin but battery is not installed.Orange, blinking: AC adapter and batteryare available and waiting to charge battery(battery is out of thermal range).Off: AC adapter is not plugged in.Battery Level IndicatorIf the battery is installed while the poweris off, the battery level indicator willdisplay the charge levels for fiveseconds after it blinks orange.If the AC adapter is not connected or thebattery pack is not fully charged whenthe computer is switched to standby mode, the indicator will blink.Batteries subjected to shocks, vibrationsor extreme temperature can bepermanently damaged.A shorted battery is damaged andMUST be replaced.Hard Drive/Optical DriveAccess IndicatorThe Hard Drive/Optical Drive Accessindicator glows green when yourinternal hard drive is being accessed.Note that flickering is normal.NumLk IndicatorThe NumLk indicator states that theintegral keyboard is set in ten-keynumeric keypad mode.CapsLock IndicatorThe CapsLock indicator states that yourkeyboard is set to type in all capital letters.ScrLk IndicatorThe ScrLk indicator states that your scrolllock is active.Common IndicatorsStatus Display PanelThe Status Indicators represent specific components ofyour Fujitsu LifeBook notebook. The LEDs below eachsymbol tell you how each of those componentsare operating.Memory Stick/SD/xD Card SlotGigabit LAN (RJ-45) JackModem JackUSB 2.0 PortsUSB PortsAir VentsExternal Video JackS-Video Out PortAnti-TheftLock SlotLithium ion BatteryBayMemory UpgradeCompartmentControls, Connectors,and Access PointsKeyboardPower/Suspend/Resume ButtonStatus Indicator PanelStatus Indicator PanelTouchpad Pointing Device oroptional Point and Write TouchpadScroll Button or Fingerprint SensorDisplay PanelDisplay Panel Latch ButtonLifeBook Application Panel with Support ButtonStereo SpeakerStereo SpeakerWireless LAN/Bluetooth On/Off SwitchMicrophone JackHeadphone JackDigital MicrophoneWeb Camera

/ 2

Related manuals for Fujitsu A6110 - LifeBook - Core 2 Duo 2.2 GHz