C160-E144-02ENOperator’s GuideFujitsu 9811 ATB printerContents---------- Operating the Printer ------------Description of each part -------------------------------------------------page 11. Outside view2. Operator panel3. Inside the printerHow to load a ribbon and coupon stock -------------------------------page 21. Opening & Closing the printer door2. Replacing the ribbon3. Installing coupon stock4. To switch print mode between “Direct Thermal print” and“Thermal transfer (with ribbon) print”5. Ready to acceptHow to remove jam paper -----------------------------------------------page 3Cleaning ----------------------------------------------------------------------page 4Status & Error Indication and recovery ----------------------------page 5---------- Printer Installation---------Environment for installation ----------------------------------------- page 11Cables ------------------------------------------------------------------------page 11Space for installation and operation --------------------------------page 12Unpacking of the printer and the Bin feeder----------------------page 13Mounting F9811 printer ----------------------------------------------- page 14Assembling Pedestal----------------------------------------------------- page 15Adjusting volume of buzzer and contrast on LCD display --- page 17Installing firmware ------------------------------------------------------ page 17Trouble Shooting ---------------------------------------------------------- page 18-------------------- Safe Operation --------------------------------------Revision record ----------------All Right Reserved, Copyright Fujitsu Ltd. 2002