Fujitsu 1740 User Manual

4 Handling the Rack after Installation 105E9 Attach the stopper wire to the door and adjust the upper and lower hingeset positions.Attach the stopper wire to the door and temporarily tighten the M5 hexagon head screw. Thisscrew will be fully tightened when the wire is attached to the rack.Adjust the hinge positions. (The upper hinge set component has been left loose since thedoor was removed.) Lower the upper hinge set component as far as it will go and thentighten the retaining screw. Fully tighten the screw while taking care not to tilt the hinge.` Tighten the retaining screws for the upper hinge set component while pressingdown on it in the direction of the lower hinge set component.Loosen the retaining screws of the lower hinge set component and then lower the componentas far as it will go. The retaining screws of the lower hinge set component will be fullytightened after the door is mounted on the rack. For now, tighten it only temporarily.’Stopper wireM5 hexagon head screwUpper hinge set component(view from the front of the door)Hinge retaining screw Full tighteningView from the rear of the doorLower hingeset componentHinge set(Two locations: upper and lower)